![]() |
![]() |
![]() |
|
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 85613 -- [Back] | |||
|
MSDS 85613 85613: Parts Washer Filter Multi Layr [1]MSDS Last updated: 02/04/2009
MATERIAL SAFETY DATA SHEET
Chem Free Corporation
8 Meca Way, Norcross, GA 30093
Tel: (770) 564-5580 Fax: (770) 564-5533
www.chemfree.com
Smart Washer
The Bioremediating Parts Washer
SECTION 1.
Product Name: Smart Washer® OzzyMat TM FL-4 Multilayer Fluid Activation Mat
Product Use: Mat and hydrocarbon degrader for the Smart Washer system.
Manufactured by: Chem Free Corporation
8 Meca Way
Norcross, GA 30093
U.S.A.
24 H Emergency Response: HEPACO (800) 888-7869
SECTION II. INGREDIENTS AND HAZARDS
HAZARDOUS % CAS # LD50 OF INGREDIENTS LC50 INGREDIENT
INGREDIENTS NUMBER (SPECIES & ROUTE) (SPECIES & ROUTE)
Non Hazardous 100 N/A N/A N/A
Proprietary water
Based degreaser all
Ingredients are listed
On the TSCA Chemical
Substance Inventory
And on the Domestic
Substance List.
SECTION III. HAZARDS IDENTIFICATION
UN Number: Not Required
Dangerous Goods Classification: Non Hazardous
HAZARD RATINGS (NFPA/HMIS)
HEALTH 0 0 = least
1 = slight
FLAMMABILITY 0 2 = moderate
3 = high
REACTIVITY 0 4 = extreme
SECTION IV. PHYSICAL / CHEMICAL CHARACTERISTICS
PHYSICAL STATE: Solid SOLUBILITY IN WATER: Forms Slurry
APPEARANCE AND ODOR: Solid filter with granular powder: Buff to brown color in
the middle.
SPECIFIC GRAVITY: 0.5 - 0.7
SECTION V. FIRST AID MEASURES
EMERGENCY & FIRST AID PROCEDURES:
EYES: It is unlikely that emergency treatment will be required: if
adverse effects occur, rinse eyes with large amounts of water until
irritation subsides. Seek medical attention if necessary.
SKIN: It is unlikely that emergency treatment will be required: if
adverse effects occur,
Rinse affected area with large amounts of water until no evidence of
chemical remains. Seek medical attention if necessary.
INGESTION: Do not ingest.
INHALATION: It is unlikely that emergency treatment will be required: if
adverse effects occur, remove to fresh air and observe. Seek medical
attention if necessary.
SECTION VI. FIRE & EXPLOSION HAZARD DATA
FLASH POINT: None METHOD USED: Open cup
FLAMMABLE LIMITS:
UPPER: None
LOWER: None
SPECIAL FIRE FIGHTING PROCEDURES: None
USUAL FIRE & EXPLOSION HAZARDS: None
SECTION VII. ACCIDENTAL RELEASE MEASURES
In the event that this material is released or spilled, sweep un/collect.
SECTION VIII. HANDLING, STORAGE & TRANSPORT INFORMATION
No special precautions are required. This product is not hazardous for storage
and transport according to the U.S. Department of Transportation Regulations.
SECTION IX. EXPOSURE CONTROLS
Exposure Limits: This product presents no health hazards to the user when used
according to label directions for its intended purposes.
VENTILATION (Local exhaust): Not required.
SECTION X. PERSONAL PROTECTION
RESPIRATORY PROTECTION (Specify Type): Not required.
PROTECTIVE GLOVES: It is recommended that rubber gloves be worn when handling
any
industrial-use products.
EYE PROTECTION: It is recommended that safety glasses be worn when handling
any
any industrial-use products.
OTHER / HYGIENIC PRACTICES: Always use good housekeeping procedures when using
any
chemical product.
SECTION XI. STABILITY AND REACTIVITY DATA
REACTIVITY: Non reactive
STABILITY: Stable
HAZARDOUS POLYMERIZATION: Will not occur
CONDITIONS TO AVOID: Avoid exposure to moisture. DO NOT WET UNTIL READY TO
USE.
Store at 32F - 105F
INCOMPATIBILITY (materials to avoid): Water should be avoided until mat is
installed
SECTION XII. TOXICOLOGICAL PROPERTIES
ROUTES OF ENTRY: Skin, Eyes
EFFECTS OF ACUTE EXPOSURE: It is unlikely that exposure will require treatment
because
product is considered a dermal non-irritant and a mild ocular
irritant.
HEALTH HAZARDS (Acute & Chronic): None
CARCINOGENICITY: None Known
TETRATOGENICITY: None known
SECTION XIII. BIODEGRADABILITY AND ENVIRONMENTAL TOXICITY INFORMATION
BIODEGRADABILITY: Biodegradable
TOXICITY INFORMATION:
48 hours LC50 value in mg/L
Ceridaphnia dubia N/A
Fathead Minnows N/A
SECTION XIV. DISPOSAL CONSIDERATIONS
WASTE DISPOSAL: Dispose of used fluid in accordance with Local, State and
Federal regulations.
SECTION XV ADDITIONAL INFORMATION
Prepared by: Karen Graham Date: June, 10 2008
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |