MSDS 85552

                       CHURCH & DWIGHT CO., INC.
                CONSUMER PRODUCTS . SPECIALTY PRODUCTS

                MATERIAL SAFETY DATA SHEET
MSDS NUMBER: MSDS-1605           ISSUE DATE: 03/12/07           

1.   PRODUCT AND COMPANY IDENTIFICATION             Church & Dwight Co., Inc.
                                                    469 N. Harrison Street
                                                    Princeton, NJ 08540

     Product Names                                  Emergency Phone:
                                                    1-800-424-9300
     OXICLEAN Versatile Stain Remover
                                                    Medical Emergency Phone:
                                                    1-888-234-1828

                                                    Customer Service
                                                    1-800-781-7529

2.   COMPOSITION/INFORMATION ON INGREDIENTS
     CAS Number                  Chemical Ingredients           % by Wt.
     0497-19-8                   Sodium carbonate               55-65%          
    15630-89-4                  Sodium carbonate Peroxyhydrate 30-40%  
     68002-97-1                  Ethoxylated  Alcohol C12-C16   2-4%

3.   HAZARDS IDENTIFICATION
                       EMERGENCY OVERVIEW
          White powder with blue specks.
          Eye irritant. May cause burning and redness. May cause skin          
          irritation. Can react with alkaline materials or metals. Can emit     
         toxic fumes if mixed with products containing chlorine or other        
         sanitizing ingredients.
          Not a fire hazard.
          This product is labeled in accordance with regulations administered 
          by the Consumer Product Safety Commission (CPSC). However, the use    
          pattern and exposure in the workplace are generally not consistent    
          with those experienced by consumers. Therefore, the requirements of   
         the Occupational Safety and Health Administration applicable to this   
         MSDS differ from the labeling requirements of the CPSC, and this MSDS  
        may contain additional health hazard information not pertinent to       
      consumer use and not found on the product label; such as appropriate      
      protective measures to prevent eye and prolonged skin contact          
         (glasses, goggles, rubber gloves, protective clothing) and minimize    
        inhalation exposure (engineering controls, NIOSH-approved respiratory   
        protection appropriate for the hazard presented) are recommended.
                             HMIS Rating
                             Health       1
                             Fire         0
                             Reactivity   0
     Potential Health Effects
     Primary Route(s) of Entry: Eyes, skin contact, inhalation, ingestion
     EYE: Potential for severe irritation if not treated immediately.Corneal    
 damage on extended exposure.
     SKIN CONTACT: Varying severities of irritation are possible from prolonged,
     repeated, or occluded exposure to skin.Contact on a burn or other wound    
 likely to cause stinging pain or irritation.
     INGESTION: Ingested amounts may cause burning and pain in the mouth and    
     throat with redness and swelling of mucous membranes. May cause pain,     
vomiting, dizziness. Harmful if swallowed.
     INHALATION: Inhaled mists may cause irritation to the upper respiratory    
     tract.
     SUBCHRONIC EFFECTS/CARCINOGENICITY: None known. Not classified as     
     carcinogenic by IARC, NTP, OSHA, OR ACGIH or NIOSH.

4.   FIRST AID MEASURES
     EYES: Immediately flush eyes with a directed stream of water for at least  
     15 minutes, forcibly holding eyelids apart to insure complete irrigation 
     of all eye and lid tissues. IF IRRITATION PERSISTS GET MEDICAL ATTENTION.

     SKIN: Remove contaminated clothing, including footwear. Wash contaminated  
     areas thoroughly with soap and water. Wash clothing before reuse. Do not   
    reuse footwear that is contaminated on the inner surfaces. GET MEDICAL     
     ATTENTION IF IRRITATION DEVELOPS.

     INHALATION: Immediately move from area of exposure to fresh air. If     
     breathing is difficult have a trained person administer oxygen. If     
     breathing has stopped, have a trained person administer artificial
     respiration. GET MEDICAL ATTENTION IMMEDIATELY.

     INGESTION: NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON. If
     ingested, do not induce vomiting. If the patient is conscious and can     
     swallow, first rinse out mouth and then give one or two glasses of water 
     to drink. GET MEDICAL ATTENTION IMMEDIATELY.

5.   FIRE FIGHTING MEASURES
     FLAMMABLE PROPERTIES                 FLAMMABLE LIMITS
     FLASHPOINT: Not flammable            LFL: Not Available
     METHOD USED:Not applicable           UFL: Not Available

     EXTINGUISHING MEDIA: CO2, powder, water spray.
     
     FIRE-FIGHTING INSTRUCTIONS: Use a self-contained breathing apparatus (SCBA)
     and full protective equipment (Bunker Gear).

     UNUSUAL FIRE AND EXPLOSION HAZARDS: Material decomposes exothermically     
when damp. Rapid evolution of oxygen may increase intensity of fire.
 
6.   ACCIDENTAL RELEASE MEASURES
     Wear personal protective equipment (See Section 8). Close off area to     
     traffic. Large spills should be contained, swept up and placed in     
containers for disposal.  
    
7.   HANDLING AND STORAGE
     Wear protective equipment when handling material to prevent skin and eye   
     contact.Avoid breathing dust.  Store in a cool, dry area away from     
incompatible substances.Keep containers closed. 
     
8.   EXPOSURE CONTROLS/PERSONAL PROTECTION
     EXPOSURE LIMITS: None
     ENGINEERING CONTROLS: General ventilation should be adequate. Use local    
     exhaust if necessary.
     RESPIRATORY PROTECTION: Not normally required. Wear a NIOSH approved     
     respirator with an organic vapor/mist cartridge where spray or mist     
     exposure occurs, or where vapors are generated from mixes with incompatible
     materials.
     PROTECTIVE GLOVES: Impervious (rubber or neoprene) gloves where contact is 
     likely.
     EYE PROTECTION: None under normal use. Use safety glasses with side     
shields or full face shields for industrial use.      
     OTHER PROTECTIVE CLOTHING OR EQUIPMENT:None. eyewash facility is     
recommended in work area or in close proximity.

9.   PHYSICAL AND CHEMICAL PROPERTIES
     APPEARANCE: White to off white powder.
     ODOR: None
     PHYSICAL STATE: Solid
     pH AS IS: 10.5 (1% in H2O)
     VAPOR PRESSURE: Not applicable
     VAPOR DENSITY: Not applicable
     BOILING POINT @ 760mm Hg: 215F
     MELTING POINT: Not applicable
     SOLUBILITY IN WATER % by WT: 140g/l @ 75F
     SURFACE TENSION: Not determined
     SPECIFIC GRAVITY (Water = 1): 1.06g/cc@20C
     VOLATILE ORGANIC COMPOUNDS: None

10.   STABILITY AND REACTIVITY
      CONDITIONS TO AVOID: High temperatures (55C, 130F), High humidity levels, 
    contaminants. 
      CHEMICAL STABILITY: Stable under normal conditions.Product will evolve    
  oxygen upon contact with water.
      INCOMPATIBILITY WITH OTHER MATERIALS: Oxidizers,reducing agents,      
flammable substances.    
      HAZARDOUS DECOMPOSITION PRODUCTS: Oxygen evolves from contaminate      
material.Evolved oxygen can support combustion.      
      HAZARDOUS POLYMERIZATION: Will not occur.

11.   TOXICOLOGICAL INFORMATION
      Acute oral toxicity: Not determined.    
      Reproductive toxicity/Teratogenicity: No components listed.
      Mutagenicity: Not determined  
      Toxicologically synergistic products: None known.
      
12.   ECOTOXICOLOGICAL INFORMATION
      TOXICITY: This product is expected to be moderately toxic to aquatic      
      animals.
      PERSISTENCE: This product is not expected to persist in the environment.
      BIOACCUMULATION: This product is moderately expected to bioaccumulate.

13.   DISPOSAL CONSIDERATIONS
      Dispose of waste product in accordance with all government regulations.   
      State and local regulations may differ from federal. Be sure to consult   
      with state and local agencies for specific rules.

14.   TRANSPORTATION INFORMATION
      DOT SHIPPING NAME: Not regulated (Data indicates that Sodium       per    
  carbonate<60% is not an oxidizer)
      DOT technical name: N/A
      DOT HAZARD CLASS: N/A
      Hazard subclass: N/A
      UN Number, proper shipping name: N/A
      Packing group: N/A
      Other Transport Information: No hazardous for transport
            
15.   REGULATORY INFORMATION
      TSCA: The components of this product are reported in the EPA TSCA      
      Inventory List.
      OSHA: Hazardous under 29 CFR 1910.1200
      CERCLA REPORTABLE QUANTITY: CERCLA requires that releases of hazardous    
      substances to land, air or water, which are equal to or exceed the      
      reportable quantity (RQ) be reported to the National Response Center      
      (800-424-8802)
      RCRA: If this material becomes waste, it would not be a hazardous waste.  
      SARA TITLE III:
      Section 302, Extremely Hazardous Substances: None
      Section 311/312, Hazardous Categories: Sodium Percarbonate-reaction      
hazard.
      Section 313, Toxic Chemicals: None
      DSL: All components listed.
      WHMIS Classification: Sodium percarbonate Class C, D2B

16.   OTHER INFORMATION
     SUPERSEDES DATE: NEW             REASON FOR REVISION: NEW

      For additional non-emergency health, safety and environmental information 
      telephone 609.279.7705 or write to:             
                             Church & Dwight Co. Inc.
                             Product Safety Affairs
                             469 North Harrison Street
                             Princeton, New Jersey 08543

      This Product Safety Data Sheet is offered solely for your information,    
      consideration and investigation. Church & Dwight Co., Inc.
      provides no warranties, either express or implied, and assumes no      
      responsibility for the accuracy or completeness of data contained
      herein. Church & Dwight Co., Inc. urges persons receiving this information
      to make their own determination as to the information suitability for     
      their particular application.


      CORPORATE HEADQUARTERS:
      469 North Harrison Street · Princeton, New Jersey 08543-5297 · 
      Phone (609)683-5900
         

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2010 Imperial Supplies LLC Questions or comments? Contact us.