MSDS 85221

                            MATERIAL SAFETY DATA SHEET

 
SW 55116 GRAY PRIMER
Imperial Part # 85221
 
PRODUCT NAME:  SW 55116 GRAY PRIMER            HMIS CODES; H   F   F   I
PRODUCT CODE;  000000000000055116
ID; 16702
 

                    SECTION I --  MANUFACTURER IDENTIFICATION

 
 
MANUFACTURER'S NAME;  CANSTO PAINT & VARNISH COMPANY
ADDRESS;                 9320 WOODLAND AVENUE
                          CLEVELAND, OHIO  44104
 
EMERGENCY PHONE;    1-800-424-9300      DATE PRINTED;  09/20/01
INFORMATION PHONE;  216-231-6115        NAME OF PREPARER; NANCY
 

            SECTION II --  HAZARDOUS INGREDIENTS/SARA 111 INFORMATION

 
                        Vapor Pressure   Weight
Reportable components      CAS Number      mm Hg @ Temp    Percent
--------------------------------------------------------------------------------
* Toluene **                108-88-3          26     68      24.19
   OSHA PEL:100 PPM,
   ACGIH TLV: 50 PPM
Isobutyl Acetate           110-19-0          18     68      14.91
   OSHA PEL:  150 PPM,
   ACGIH TLV; 150 PPM
*Methyl Ethyl Ketone     78-93-3            78     68      7.07
   OSHA PEL: 200 ppm,
   ACGIH TLV 200 ppm
N. Butyl Acetate           123-86-4          13     68 F    3.78
   OSHA PEL: 150 ppm,
   ACGIH TLV; 200 ppm
*Xylene                      1330-20-7          21     100 F    1.60
   OSHA PEL: 100 ppm,
   ACGIH TLV; 50 ppm
Ethyl Benzene                100-41-4          7.1     68      0.08
   OSHA PEL: 100 PPM
   ACGIH TLV; 100 PPM   
 
·   Indicates toxic chemical (s) subject to the reporting requirements of section 
313 of Title 111 and of 50 CFR372.* 
 

                 SECTION III -  PHYSICAL/CHEMICAL CHARACTERISTICS

 
BOILING RANGE:  175 deg F - 279 - 289 F   
SPECIFIC GRAVITY (H20=1); 1.17
VAPOR DENSITY;  HEAVIER THAN AIR
EVAPORATION RATE; SLOWER THAN ETHER
COATING V.O.C. : 5.03  lb/gal
MATERIAL V.O.C.:  503  lb/gl
SOLUBILITY IN WATER; NEGLIGIBLE
APPEARANCE AND ODOR; GRAY LIQUID / STRONG SOLVENT
 

                   SECTION IV -  FIRE AND EXPLOSION HAZARD DATA

 
FLASH POINT;  23            METHOD; USED;  TCC
FLAMMABLE LIMITS IN AIR BY VOLUME - LOWER; 1   UPPER;  11.5
 
EXTINGUISHING MEDIA; EXTINGUISH LARGE FIRES WITH WATER SPRAY OR FOAM. USE CO2 
OIL DRY CHEMICAL ON SMALL FIRES. 
 
SPECIAL FIREFIGHTING PROCEDURES
Wear full firefighting protective equipment. Including air supplied breathing 
apparatus and protective clothing. 
 
UNUSUAL FIRE AND EXPLOSION HAZARDS
Keep containers tightly closed. Isolate from heat, electrical equipment, sparks 
and open flame. Closed containers may explode when exposed to extreme heat. Do 
not apply to hot surfaces. 
 

                          SECTION V --  REACTIVITY DATA

 
STABILITY;  Stable under recommended handling and storage conditions. 
CONDITIONS TO AVOID; High temperatures
INCOMPATIBILITY  (MATERIALS TO AVOID)  NA
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: May produce hazardous fumes when heated: 
Carbon Monoxide, Oxides of Nitrogen, Hydrogen Chloride.
HAZARDOUS POLYMERIZATION;  Will not occur.
 

                        SECTION VI --  HEALTH HAZARD DATA

 
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Avoid inhaling solvent vapors. Excessive inhalation may cause headaches, 
dizziness, and/or nausea. NIOSH approved respirators recommended if vapors and 
mists are generated as in spray application.
 
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Skin or eye contact - Primary irritation.
 
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Prolonged or repeated exposure to this material may cause redness and burning, 
drying and cracking of the skin and dermatitis.  Persons with pre-existing skin 
disorders may be more susceptible. 
 
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Do not induce vomiting. Consult a physician or poison control center.
 
HEALTH HAZARDS  (ACUTE AND CHRONIC)
Repeated and prolonged exposure to solvents may cause permanent brain and/or 
nervous system damage. Symptoms include loss of memory, loss of intellectual 
ability, and loss of coordination, caution; contains Toluene - May be harmful to 
the fetus based on laboratory animal studies.
 
CARCINOGENICITY;  
NTP CARCINOGEN; No      IARC MONOGRAPHS; No     OSHA REGULATED; No

Contains very low levels of Benzene as a impurity either of Toluene or Xylene. 
Our MSDS on the products indicate the specific solvents present. Benzene is 
classified by the State of California as a cancer hazard. 
 
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Any medical condition, allergy or sensitization can become worse upon exposure. 
 
EMERGENCY AND FIRST AID PROCEDURES
Fumes-remove from exposure. Restore breathing. Keep away and quiet. Notify a 
physician. Ingestion-Do not induce vomiting. Consult a physician or poison 
control center. Eyes-flush immediately with large amounts of water for 15 
minutes. See a physician. Skin-Wash affected areas thoroughly with soap and 
water. Remove contaminated clothing. 
 

              SECTION VII --  PRECAUTIONS FOR SAFE HANDLING AND USE

 
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Remove all sources of ignition. Ventilate area. Remove with inert absorbent and 
non-sparking tools. 
 
WASTE DISPOSAL METHOD
Dispose in accordance with local, state and federal regulation. Incinerate in 
approved facility. Do not incinerate closed containers. Emptied containers may 
retain hazardous residue and explosive vapors. 
 
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Do not store above 120F. Store large quantities in buildings designed and 
protected for storage of NFPA Class Liquids.  Ground containers when pouring. 
Avoid free fall of liquid in excess of a few inches. Do not flame cut, braze or 
weld.
 
OTHER PRECAUTIONS
California Proposition 65 contains - Benzene - All components in this product 
have been verified as being on the TSCA Inventory and the Canadian DSL.
 

                         SECTION VIII -  CONTROL MEASURES

 
RESPIRATORY PROTECTION
Use an approved respirator if exposure exceeds PEL LIMITS.
 
VENTILATION
Users should wear appropriate, properly fitted respirators (NIOSH/MSHA 
approved).
During spraying application. A self-contained breathing apparatus is strongly 
recommended. 
 
PROTECTIVE GLOVES
Wear resistant gloves such as; Natural rubber, or Neoprene
 
EYE PROTECTION
Chemical splash goggles in compliance with OSHA regulation
 
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
To prevent repeated or prolonged skin contact, wear impervious clothing and 
boots. 
 
WORK/HYGIENIC PRACTICES
Wash hands before eating or using the washrooms, smoke in smoking areas only.
 

                            SECTION IX --  DISCLAIMER

 
We believe the information contained in this MSDS is correct as of this date 
however because the material may be used under conditions over which we have no 
control we give no warranty and assume no responsibility for any damage to 
person property or business arising from such use. It is the responsibility of 
the user to ensure it is properly used. 

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.