Start an Order |
|
|
|
| Start an Order |
|||
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 82120 -- [Back] | |||
|
MSDS 82120 82120: Electronic Solder Lead Free [2]82121: 1/2 Lb Rosin Solder [1] 82122: 1 Lb Rosin Solder [1] MSDS Last updated: 03/18/2005
COOKSON ELECTRONICS
A Division of Cookson Group plc Alpha Metals
Revised 11/04/04 600 Route 440
Replaces 7/21/04 Jersey City, NJ 07304
Printed 1/10/05 (201) 434-6778
MSDS ID; FT004RCLF (201) 434-7508 fax
www.alphametals.com
MATERIAL SAFETY DATA SHEET
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: LEAD FREE ROSIN CORE WIRE (RA, RMA, RSA, NC -
RELIACORE, TELECORE, SMT, ENERGIZED,
ENERGIZED PLUS, PLASTICORE)
LEAD FREE ROSIN PASTE
MANUFACTURER'S NAME: COOKSON ELECTRONICS ASSEMBLY
MATERIALS GROUP
4100 6th AVENUE
ALTOONA, PA 16602
TRANSPORT EMERGENCY #: CHEMTREC; 1-800-424-9300
BUSINESS PHONE: 1-814-946-1611
2. INGREDIENT AND EXPOSURE LIMIT INFORMATION
CHEMICAL NAME CAS # % W/W OSHA PEL - TWA
--------------------------------------------------------------------------------
TIN 7440-31-5 2.0 mg/m3
SILVER 7440-22-4 0.1 mg/m3
ANTIMONY 7440-36-0 0.5 mg/m3
BISMUTH 7440-69-9 N/E
COPPER 7440-50-8 0.1 mg/m3 (fume,CuO)
1.0 mg/m3 (dusts &
mists as CU)
GOLD 7440-57-5 N/E
WW GUM ROSIN * 8050-09-7 N/E
PROPYLENE GLYCOL ETHER 1589-47-5 100 PPM
TETRAHYDROFURFURYL 97-99-4 2 PPM
ALCHOL
RESIN H * 65997-06-0 N/E
PRODUCT CONTAINS ONE OR MORE OF THE ABOVE LISTED CHEMICALS IN VARYING
PERCENTAGES. SEE PRODUCT LABEL FOR EXACT COMPOSITION.
· SENSITIZER REDUCE EXPOSURE TO AS LOW AS POSSIBLE
3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW: MODERATE EYE IRRITANT, WILL NOT BURN.
TOXIC BY INHALATION. GASTROINTESTINAL
TRACT IRRITANT. RESPIRATORY TRACT
IRRITANT. CAUSES SKIN IRRITATION.
HMIS RATING SYSTEM;
Health: 1 Flammability: 1 Reactivity: 0 Protection: B
NFPA RATING SYSTEM;
Health: 1 Flammability: 1 Reactivity: 0
ROUTES OF ENTRY: INHALATION; INGESTION
TARGET ORGANS: BLOOD: KIDNEYS: SKIN: RESPIRATORY SYSTEM:
NASAL SEPTUM: LIVER: EYES.
MEDICAL CONDITIONS AGGRAVATED: DIGESTIVE TRACT DISEASE:
KIDNEY DISEASE
IMMEDIATE (ACUTE) SYMPTOMS OVER-EXPOSURE BY ROUTE OF
EXPOSURE;
INHALATION: CAN CAUSE MODERATE RESPIRATORY IRRITATION,
DIZZINESS, WEAKNESS, FATIGUE, NAUSEA AND
HEADACHE.
EYES: CAN CAUSE MODERATE IRRITATION, TEARING AND
REDDENING, BUT NOT LIKELY TO PERMANENTLY
INJURE EYE TISSUE.
SKIN CONTACT: CAN CAUSE SLIGHT IRRITATION.
INGESTION: IRRITATING TO MOUTH, THROAT, AND STOMACH.
CAN CAUSE ABDOMINAL DISCOMFORT, NAUSEA,
VOMITING AND DIARRHEA.
LONG TERM (CHRONIC) HEALTH EFFECTS:
CARCINOGENICITY: AT THIS TIME CADMIUM IS A SUSPECTED HUMAN
CARCINOGEN BY THE NTP, IARC, OR OSHA.
SEE SECTION 11 OF THE MSDS FOR ADDITIONAL INFORMATION
REPRODUCTION: SEE SECTION 11 OF THIS MSDS.
MUTACENICITY; SEE SECTION 11 OF THIS MSDS
4. FIRST AID MEASURES
SKIN EXPOSURE; WASH WITH SOAP AND WATER. REMOVE
CONTAMINATED CLOTHING AND LAUNDER.
GET MEDICAL ATTENTION IF IRRITATION DEVELOPS
OR PERSISTS.
EYE EXPOSURE: FLUSH EYES WITH PLENTY OF WATER FOR AT LEAST
20 MINUTES RETRACTING EYELIDS OFTEN. TILT THE
HEAD TO PREVENT CHEMICAL FROM TRANSFERRING
TO THE UNCONTAMINATED EYE. GET IMMEDIATE
MEDICAL ATTENTION.
INHALATION: REMOVE TO FRESH AIR. IF BREATHING IS DIFFICULT,
HAVE A TRAINED INDIVIDUAL ADMINISTER OXYGEN.
IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION
AND HAVE A TRAINED INDIVIDUAL ADMINISTER
OXYGEN. GET MEDICAL ATTENTION IMMEDIATELY.
INGESTION; SEEK MEDICAL ATTENTION IMMEDIATELY.
NOTES TO DOCTOR: NO ADDITIONAL FIRST AID INFORMATION AVAILABLE
5. FIRE FIGHTING MEASURES
FLAMMABILITY SUMMARY: NOT COMBUSTIBLE
FLASH POINT: N/A
AUTOIGNITION TEMPERATURE: N/E
EXPLOSIVE LIMITS % IN AIR: N/E
FIRE FIGHTING METHODS; WILL NOT BURN, NO SPECIAL INSTRUCTIONS
AVAILABLE. USE METHODS APPROPRIATE FOR
SURROUNDING MATERIALS.
HAZARDOUS COMBUSTION PRODUCTS; METAL FUMES; TOXIC FUMES.
6. ACCIDENTAL RELEASE MEASURES
PRECAUTIONS AND EQUIPMENT: EXPOSURE TO THE SPILLED MATERIAL
MAY BE IRRITATING OR HARMFUL. FOLLOW
PERSONAL PROTECTIVE EQUIPMENT
RECOMMENDATIONS FOUND IN SECTION VIII OF
THIS MSDS.
METHODS FOR CLEAN-UP: WEAR COMPLETE AND PROPER PERSONAL
PROTECTIVE EQUIPMENT FOLLOWING THE
RECOMMENDATION OF SECTION VIII GATHER AND
STORE IN A SEALED CONTAINER PENDING A WASTE
DISPOSAL EVALUATION. DO NOT USE BROOM OR AIR
CLEANING ETC.
7. HANDLING AND STORAGE
HANDLING MEASURES: HARMFUL OR IRRITATING MATERIAL. AVOID
CONTACTING AND AVOID BREATHING THE MATERIAL.
USE ONLY IN A WELL VENTILATED AREA. AS WITH
ALL CHEMICALS, GOOD INDUSTRIAL HYGIENE
PRACTICES SHOULD BE FOLLOWED WHEN HANDLING
THIS MATERIAL. AVOID CONTACT WITH MATERIAL,
AVOID BREATHING DUSTS OR FUMES, USE ONLY IN A
WELL VENTILATED AREA. WASH THOROUGHLY AFTER
HANDLING; WASH HANDS BEFORE EATING; DO NOT GET
IN EYES, ON SKIN AND CLOTHING; MINIMIZE DUST
GENERATION AND ACCUMULATION; REMOVE
CONTAMINATED CLOTHING AND WASH BEFORE REUSE.
STORAGE MEASURES; NO SPECIAL REQUIREMENTS.
STORE IN A TIGHTLY CLOSED CONTAINER; KEEP AWAY
FROM FOOD AND DRINKING WATER. STORE IN A COOL
DRY PLACE: KEEP AWAY FROM HEAT, SPARKS, AND
FLAME.
8. EXPOSURE CONTROLS AND PERSONAL PROTECTION
ENGINEERING MEASURES: USE LOCAL EXHAUST VENTILATION OR OTHER
ENGINEERING CONTROLS TO MINIMIZE EXPOSURES
AND MAINTAIN OPERATOR COMFORT.
ENGINEERING CONTROLS MUST BE DESIGNED TO MEET
THE OSHA CHEMICAL SPECIFIC STANDARD IN 29 CFR
1910. VENTILATION IS REQUIRED TO MAINTAIN
OPERATOR EXPOSURE BELOW PUBLISHED EXPOSURE
LIMITS. USE PROCESS ENCLOSURES. LOCAL EXHAUST
VENTILATION, OR OTHER ENGINEERING CONTROLS TO
CONTROL AIRBORNE LEVELS BELOW RECOMMENDED
EXPOSURE LIMITS.
RESPIRATORY PROTECTION; RESPIRATORY PROTECTION MAY BE
REQUIRED TO AVOID OVER EXPOSURE WHEN
HANDLING THIS PRODUCT. GENERAL OR LOCAL
EXHAUST VENTILATION IS THE PREFERRED MEANS
OF PROTECTION. USE A RESPIRATOR IF GENERAL
ROOM VENTILATION IS NOT AVAILABLE OR
SUFFICIENT TO ELIMINATE SYMPTOMS. FOLLOW A
RESPIRATORY PROTECTION PROGRAM THAT MEETS
29 CFR 1910.134 AND ANSI Z88.2 REQUIREMENTS
WHENEVER WORK PLACE CONDITIONS WARRANT THE
USE OF A RESPIRATOR. WEAR A NIOSH APPROVED
RESPIRATOR IF ANY EXPOSURE IS POSSIBLE.
EYE PROTECTION: WEAR CHEMICALLY RESISTANT SAFETY GLASSES WITH
SIDE SHIELDS WHEN HANDLING THIS PRODUCT. DO NOT
WEAR CONTACT LENSES.
WEAR GOGGLES AND A FACE SHIELD
SKIN PROTECTION: WEAR PROTECTIVE GLOVES. INSPECT GLOVES FOR
CHEMICAL BREAK-THROUGH AND REPLACE AT
REGULAR INTERVALS. CLEAN PROTECTIVE EQUIPMENT
REGULARLY. WASH HANDS AND OTHER EXPOSED
AREAS WITH MILD SOAP AND WATER BEFORE EATING,
DRINKING, AND WHEN LEAVING WORK.
WHERE CONTACT IS LIKELY, WEAR CHEMICAL
RESISTANT GLOVES, A CHEMICAL SUIT, RUBBER
BOOTS, AND CHEMICAL SAFETY GOGGLES PLUS A
FACE SHIELD.
CONTROL PARAMETERS: ACGIH EXPOSURE LIMITS
CHEMICAL NAME TLV-TWA STEL CEILING
--------------------------------------------------------------------------------
TIN 2 mg/m3 TWA
SILVER 0.1 mg/m3
ANTIMONY 0.5 mg/m3 TWA
BISMUTH N/E
COPPER 1 mg/m3
GOLD N/E
0.1 mg/m3 (as copper fume)
WW GUM ROSIN SESATIZER REDUCE EXPOSURE
TO AS LOW AS POSSIBLE
ROSIN SH SENSATIZER REDUCE EXPOSURE
TO AS LOW AS POSSIBLE
9. PHYSICAL AND CHEMICAL PROPERTIES
COLOR; GREY
ODOR: NONE
pH; N/A
SOLUBILITY IN WATER; NEGLIGIBLE: 0-1%
OTHER PHYSICAL AND CHEMICAL PROPERTIES DEPEND ON ALLOY COMPOSITION.
10. STABILITY AND REACTIVITY
DECOMPOSITION PRODUCTS: METAL FUMES: TOXIC FUMES.
INCOMPATIBLE MATERIALS: PEROXIDES; STRONG ACIDS: STRONG
OXIDIZING AGENTS; STRONG REDUCING
AGENTS; ACIDS; CHLORINE; MOISTURE;
STRONG ALKALIES.
CONDITIONS TO AVOID: NONE KNOWN
CONTAMINATION; CONTACT WITH AIR.
CONTACT WITH WATER
11. TOXICOLOGICAL INFORMATION
INHALATION AND INGESTION; INGESTION OF DUST OR FUME MUST BE
AVOIDED.
ANTIMONY; ANTIMONY IS TOXIC AND DUST OR FUME CAN CAUSE
NASAL SEPTAL ULCERATION AND STOMACH LINING
IRRITATION, SLEEPLESSNESS, IRRITABILITY, AND
MUSCULAR PAIN.
TIN: TIN IS NOT REGARDED AS TOXIC BUT EXCESSIVE
EXPOSURE CAN CAUSE FEVER, NAUSEA, STOMACH
CRAMPS OR DIARRHEA. DUST OR FUME MAY CAUSE
IRRITATION OF THE SKIN AND MUCOUS MEMBRANES
AND MAY RESULT IN A BENIGN PNEUMOCONIOSIS
(STANNOSIS).
COPPER; COPPER DUST AND FUME AFFECT THE RESPIRATORY
SYSTEM, LUNGS SKIN, LIVER AND EYES.
BISMUTH;BISMUTH IS NOT CONSIDERED HAZARDOUS.
SILVER: SILVER MAY CAUSE DISCOLORATION OF EYES AND
SKIN (ARGYRIA)
12. ECOLOGICAL INFORMATION
OVERVIEW; ECOLOGICAL HAZARD. IN HIGH CONCENTRATIONS,
THIS PRODUCT MAY BE DANGEROUS TO PLANTS AND/
OR WILDLIFE.
13. DISPOSAL CONSIDERATIONS
WASTE DESCRIPTION: RETURN TO SUPPLIER TO BE RECYCLED FOR METAL
UNIT VALUE. SPENT OR DISCARDED MATERIAL IS
PROBABLY A HAZARDOUS WASTE.
DISPOSAL METHODS; DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE,
LOCAL OR PROVINCIAL LAWS AND REGULATIONS.
14. TRANSPORT INFORMATION
SHIPPING BASIC DESCRIPTION: DOT & IATA: NOT RESTRICTED UNLESS IN
FINE PARTICLE SIZE LESS THAN 0.004 INCHES IN
DIAMETER. DEPENDS ON ALLOW. CONSULT LABEL OR
MANUFACTURER FOR ADDITIONAL INFORMATION.
15. REGULATORY INFORMATION
TSCA STATUS: ALL COMPONENTS OF THIS PRODUCT ARE LISTED ON THE
TSCA INVENTORY OF EXISTING CHEMICAL
SUBSTANCES.
REGULATED CHEMICALS:
CHEMICAL NAME: REGULATION
--------------------------------------------------------------------------------
SILVER 7440-22-4 SARA 313
ANTIMONY 7440-36-0 SARA 313
COPPER 7440-50-8 SARA 313
16. OTHER INFORMATION
The information contained herein is based on data considered accurate. However,
no warranty is expressed or implied regarding the accuracy of the data or the
results to be obtained from the use thereof. Additionally, Alpha Metals, Inc.
assumes no responsibility for injury to the vendee or third persons proximately
caused by the material even if reasonable safety procedures are followed.
Furthermore, vendee assumes the risk in his use of the material.
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |
Printer-Friendly View
