MSDS 9180

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                     Material Safety Data Sheet

1. PRODUCT IDENTIFICATION
Product Name:             120DA BELT DRESSING & CONDITIONER 12 OZ AE
Item No:                  80073
Product Type:             Aerosol coating

2. COMPOSITION/INFORMATION ON INGREDIENTS
Component           Weight%       ACGIH TLV: TWA          OSHA PEL:
                                         
W A TE R            60-100        Not Listed              Not Listed
7732-1                                   
                                                                                

N-HEXANE
110-54-3            10-30         50 ppm TWA              500 ppm TWA           
                                    <10                  1000 ppm TWA           
     Not Listed
PETROLEUM GASES, LIQUEFIED,
SW EETENED
68476-86-8
                         <10                 Not Listed                   Not
Listed
POLYBUTYLENE RESIN
9003-29-6


3. HAZARDS IDENTIFICATION

Toxicity:  May cause eye, skin and respiratory irritation. May cause
           nervous system depression. Excessive inhalation causes headache,
           dizziness, nausea, and incoordination.

Primary Routes of Entry:  Eye and skin contact, ingestion, inhalation

Signs and Symptoms of Exposure: Excessive overexposure may cause giddiness,
                    dizziness, headache, nausea and in extreme cases,
                    unconsciousness and respiratory depression. Overexposure
                    may cause eye and skin redness.

Medical Conditions Recognized as
Being Aggravated by Exposure: None Known

4. FIRST AID MEASURES
Ingestion:    If swallowed, DO NOT induce vomiting. Keep individual calm.
              Obtain medical attention. 
Inhalation:   Move to fresh air in case of accidental inhalation of
              vapours. Obtain medical attention.
Skin Contact: Wash off with soap and water. If skin irritation persists,
              call a physician.
Eye Contact:  In case of contact, immediately flush eyes with plenty of water
              for at least 15 minutes and get medical attention if irritation
              persists.

5. FIRE FIGHTING MEASURES
                                    No flame projection
Flash Point (°F/C):
                                    Carbon Dioxide, Dry Chemicals, Foam.
Recommended Extinguishing Media:
                                    Firefighters should wear self-contained
breathing apparatus. Keep
Special Fire-Fighting Procedures:
                                    containers cool. Use equipment or shielding
required to protect against
                                    bursting or venting of containers. Water
spray may be ineffective on flames
                                    but should be used to keep fire-exposed
containers cool.
                                    Oxides of carbon
Hazardous Products of Combustion:
                                    Contents under pressure. Exposure to
temperatures over 120 degrees F.
Unusual Fire/Explosion Hazards:
                                    may cause bursting or venting. Keep
containers cool.

                                    Not determined
Lower Explosive Limit:
                                    Not determined
Upper Explosive Limit:

6. ACCIDENTAL RELEASE MEASURES
                     Maintain good ventilation. Take up with an inert absorbent.
Store in a closed waste container until
Spill Procedures:
                     disposal.




                                 1 of 3
Product Name: 120DA BELT DRESSING &                                             
 Item No: 80073
         CONDITIONER 12 OZ AE


7. HANDLING AND STORAGE
                    Store away from heat, sparks or open flame. Do not store at
temperatures above 120 degrees F.
Storage:
                    Exposure to high temperatures may cause container to burst.
                    Avoid contact with skin and eyes. Do not inhale vapors. Do
not puncture or incinerate container. Do not
Handling:
                    use near heat, sparks or open flame. Use in a well
ventilated area to prevent irritation by vapors. Wash
                    hands before eating and smoking.


8. EXPOSURE CONTROLS/PERSONAL PROTECTION
                    Safety glasses
Eyes:
                    Rubber or plastic gloves.
Skin:
                    General; local exhaust ventilation as necessary to control
any air contaminants to within their exposure
Ventilation:
                    limits (or to the lowest feasible levels when limits have
not been established) during the use of this
                    product.
                    Not normally necessary. An approved respirator (i.e. NIOSH,
etc.) should be worn when exposures are
Respiratory Protection:
                    expected to exceed the applicable limits.


9. PHYSICAL AND CHEMICAL PROPERTIES
                    Creamy white emulsion
Appearance:
                    Sweet Odor
Odor:
                    >200°F
Boiling Point:
                    Not available
pH:
                    SOLUBLE
Solubility in Water:
                    0.9-1.0
Specific Gravity:
                    15%
VOC Content(Wt.%):
                    Not Determined
Vapor Pressure:
                    Heavier than air
Vapor Density (Air=1):
                    <1 (butyl acetate = 1)
Evaporation Rate:

10. STABILITY AND REACTIVITY
                                     Stable at normal conditions
Chemical Stability:
                                     W ILL NOT OCCUR.
Hazardous Polymerization:
                                     Strong oxidizers
Incompatabilities:
                                     Keep away from heat, sparks and open flame
Conditions to Avoid:
                                     Oxides of carbon
Hazardous Products of Combustion:

11. TOXICOLOGICAL INFORMATION
 See Section 3


12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations. This container may be
                    recycled in aerosol recycling centers. Before offering for
recycling, empty the can by using the product
                    according to the label. If recycling is not available, wrap
the container and discard in the trash.
                    D001 as per 40CFR 261.21
US EPA Waste Number:

14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
                    CONSUMER COMMODITY
       DOT Shipping Name:
                    ORM-D
       Hazard Class:
                    None
       UN/ID Number:
                    None
       Marine Pollutant:

IATA
                    Consumer Commodity (Not more than 1 liter)
       Proper Shipping Name:
                    Class 9
       Class or Division:
                    ID 8000
       UN/NA Number:

IMDG
                    Aerosols, Limited Quantity
       Proper Shipping:
                                       2 of 3
Product Name: 120DA BELT DRESSING &                                        Item
No: 80073
         CONDITIONER 12 OZ AE

                        Class 2.2
      Hazard Class:
                        UN 1950
      UN Number:

15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313
Toxic Chemical.

HEXANE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.

TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.

16. OTHER INFORMATION
                         HEALTH 1, FLAMMABILITY 1 , REACTIVITY 0.
Estimated NFPA Rating:
                         HEALTH 1, FLAMMABILITY 1, PHYSICAL HAZARD 0
Estimated HMIS Classification:
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.



             Denise Boyd, Health and Safety Manager
Prepared By:                                       Revision Date:
December/21/2007
             Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106            
4
Company:                                      Revision
                                         Number:




                                 3 of 3

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.