MSDS 9122

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106  USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                 MATERIAL SAFETY DATA SHEET

1. PRODUCT IDENTIFICATION
Product Name:      HIGH TEMPERATURE THREAD SEALANT 250 ML
Item No:           59225
Product Type:      Anaerobic

2. COMPOSITION/INFORMATION ON INGREDIENTS

Component        Weight %          ACGIH TLV:TWA         OSHA PEL

Poly Glycol      20-40             Not Listed            Not Listed
Dimethacrylate
25852-47-5

Polyester Resin  10-30             Not Listed            Not Listed
Mixture

Silica, Mica     10-30             3 mg/m3 TWA           20 mppcf TWA
12001-26-2

Octanol          <20               Not Listed            Not Listed
111-87-5

Polyethylene     <20               Not Listed            Not Listed
Glycol Ester
18268-70-7

Polytetrafluoroethylene  <5        Not Listed            Not Listed
9002-84-0

Treated Silicon Dioxide  <5        10 mg/m3              10 mg/m3
Synthetic, Crystalline-Free       total dust TLV        total dust
67762-90-7

Titanium Dioxide         <3        10 mg/m3              15 mg/m3
13463-67-7                        TWA ACGIH             TWA (total dust)
                                                              
Propylene Glycol         <3       Not Listed            Not Listed
57-55-6

Dimethyl benzyl          <2       Not Listed            Not Listed
Hydro peroxide
80-15-9

Saccharin             0.5-5.0     10 mg/m3              Not Listed
81-07-2                          nuisance dust

3. HAZARD IDENTIFICATION
Toxicity:        Ingestion may irritate digestive tract and cause nausea,
                 vomiting and diarrhea. May cause eye and skin irritation.
                 May cause skin sensitization. Note: This product does
                 not contain microcrystalline silica.
Primary Routes of Entry: Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure: Repeated skin contact may cause allergic
                 skin reactions. May cause redness to eyes and
                 irritation to nasal passages.

Component                 Weight %     NTP        ACGIH          IARC
                                                  Carcinogens
Polytetrafluoroethylene    <5                                    Group 3
9002-84-0                                                        Supplement 7,
                                                                 1987:
                                                                 Monograph
                                                                 19, 1979

Titanium Dioxide           <3       male rat-      A4            Group 2B:
13463-67-7                          negative                     Vol 93, 2006
                                    Female rat-                  Vol 47,1989
                                    negative, male
                                    mice-negative,
                                    female mice-
                                    negative.

Saccharin              0.5-5.0      Delisted April             Group 3: Vol 73
81-07-2                             2000                       Page 517: 1999   
                                                      
                                                   

Medical Conditions Recognized as  Preexisting skin disorders
Being Aggravated by Exposure:

4. FIRST AID MEASURES
Ingestion:             If swallowed, DO NOT induce vomiting.
                       Keep individual calm.
                       Obtain medical attention.
Inhalation:            Move to fresh air in case of accidental inhalation
                       of vapors. Obtain medical attention.
Skin Contact:          Wash off with soap and water.
                       If skin irritation persists, call a physician.
Eye Contact:           In case of contact, immediately flush eyes with
                       plenty of water for at least 15 minutes and get
                       medical attention if irritation persists.

5. FIRE FIGHTING MEASURES
Flash Point (F/C):     >200 degrees F   TCC
Recommended Extinguishing Media:  Water fog, carbon dioxide, foam,
                       dry chemical.
Special Fire-Fighting Procedures:  Firefighters should wear self-contained
                       breathing apparatus.
Hazardous Products of Combustion:  Irritating vapors. Oxides of carbon.
Unusual Fire/Explosion Hazards:  None.

Lower Explosive Limit: 1.0: Octanol
Upper Explosive Limit: 8.0: Octanol

6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:      Maintain good ventilation. Take up with an inert
                       absorbent. Store in a closed waste container until
                       disposal.

7. HANDLING AND STORAGE
Storage:               Store below 100 degrees F. Keep in cool and dark
                       place. Avoid direct sunlight.
Handling:              Avoid prolonged skin contact. Keep away from
                       eyes.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:                  Safety glasses.
Skin:                  Rubber or plastic gloves.
Ventilation:           General: local exhaust ventilation as necessary to
                       control any air contaminants to within their
                       exposure limits (or to the lowest feasible levels
                       when limits have not been established) during the
                       use of this product.
Respiratory Protection: An approved respirator (i.e.NIOSH,etc.) should be
                       worn when exposures are expected to exceed the
                       applicable limits.

9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:            White paste
Odor:                  MILD
Boiling Point:         >300 degrees C.
pH:                    Does not apply
Solubility in Water:   Insoluble
Specific Gravity:      1.2
VOC Content (Wt.%):    10 % by weight
Vapor Pressure:        Not determined
Vapor Density (Air=1): Heavier than air
Evaporation Rate:      Not Determined

10. STABILITY AND REACTIVITY
Chemical Stability:          Stable at normal conditions
Hazardous Polymerization:    WILL NOT OCCUR
Incompatibilities:           Metal salts, heat and amines.
Conditions to Avoid:         Heat
Hazardous Products of Combustion:  Irritating vapors. Oxides of carbon

11. TOXICOLOGICAL INFORMATION
See Section 3

12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:  Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not a RCRA Hazardous Waste Material

14. TRANSPORTATION INFORMATION
DOT  (49CFR 172)
Domestic Ground Transport
      DOT Shipping Name:     Unrestricted
      Hazard Class:          None
      UN/ID Number:          None
      Marine Pollutant:      None

IATA
      Proper Shipping Name:  Not regulated
      Class or Division:     None
      UN/NA Number:          None

IMDG
      Proper Shipping:       Unrestricted
      Hazard Class:          None
      UN Number:             None

15. REGULATORY INFORMATION
SARA 313 Chemicals:  The following component(s) is listed as a SARA Section 313
Toxic Chemical.

DIMETHYL BENZYL HYDRO PEROXIDE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.

TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.

16. OTHER INFORMATION
Estimated NFPA Rating:            Health 2, Flammability 1, Reactivity 1
Estimated HMIS Classification:    Health 2, Flammability 1, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.

Prepared By: Denise Boyd, Health and Safety Manager   Revision Date:
                                                      August/14/2007
Company: Permatex, Inc 10 Columbus Blvd. Hartford, CT USA 06106
                                                      Revision   1
                                                      Number:

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.