MSDS 9119

Permatex, Inc.
10 Columbus Blvd.
Hartford, Ct  06106  USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                  MATERIAL SAFETY DATA SHEET

1. PRODUCT IDENTIFICATION
Product Name:  HIGH TEMPERATURE THREAD SEALANT 6ML
Item No:       59214
Product Type:  Anaerobic


2. COMPOSITION/INFORMATION ON INGREDIENTS
Component                 Weight%           ACGIH TLV: TWA       OSHA PEL:
Polyglycol Dimethacrylate 20-40             Not Listed          Not Listed
25852-47-5


Polyester Resin           10-30             Not Listed          Not Listed
Mixture


Silica, Mica              10-30             3 mg/m3 TWA         20 mppcf TWA
12001-26-2


Octanol                   <20               Not Listed          Not Listed
111-87-5


Polyethylene Glycol       <20               Not Listed          Not Listed
Ester
18268-70-7


Polytetrafluoroethylene   <5                Not Listed          Not Listed
9002-84-0


Treated Silicon Dioxide   <5                10 mg/m3            10 mg/m3
Synthetic, Crystalline-                    total dust TLV      total dust
Free
67762-90-7          
                  

Titanium Dioxide          <3               10 mg/m3 TWA        15 mg/m3 TWA
13463-67-7                                  ACGIH              (total dust)


Propylene Glycol          <3                 Not Listed         Not Listed
57-55-6


Dimethylbenzyl            <2                 Not Listed         Not Listed
Hydroperoxide
80-15-9


Saccharin               0.5-5.0              10 mg/m3           Not Listed
81-07-2                                    nuisance dust


3. HAZARDS IDENTIFICATION
Toxicity:    Ingestion may irritate digestive tract and cause nausea,
             vomiting and diarrhea. May cause eye and skin irritation.
             May cause skin sensitization. Note:  This product does
             not contain microcrystalline silica.
Primary Routes of Entry:  Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure:  Repeated skin contact may cause allergic
             skin reactions. May cause redness to eyes and irritation to nasal
             passages.
Component               Weight%      NTP            ACGIH       IARC
                                                  Carcinogens
Polytetrafluoroethylene   <5                                     Group 3
9002-84-0                                                        Supplement 7,
                                                                1987: Monograph
                                                                19, 1979


Titanium Dioxide          <3     male rat-negative   A4        Group 2B:
13463-67-7                       female rat-negative           Vol 93, 2006:
                                 Male mice-negative,           Vol 47, 1989
                                 Female mice-negative


Saccharin             0.5-5.0    Delisted April 2000          Group 3: Vol 73,
81-07-2                                                       Page 517: 1999


Medical Conditions Recognized as      Preexisting skin disorders
Being Aggravated by Exposure:


4. FIRST AID MEASURES
Ingestion:           If swallowed, DO NOT induce vomiting. Keep
                     individual calm. Obtain medical attention.
Inhalation:          Move to fresh air in case of accidental inhalation
                     of vapors. Obtain medical attention.
Skin Contact:        Wash off with soap and water. If skin irritation
                     persists, call a physician.
Eye Contact:         In case of contact, immediately flush eyes with plenty of
                     water for at least 15 minutes and get medical attention if
                     irritation persists.


5. FIRE FIGHTING MEASURES
Flash Point (degree F/C): >200 degree F  TCC
Recommended Extinguishing Media:  Water fog, carbon dioxide, foam, dry
                          chemical.
Special Fire-Fighting Procedures:  Firefighters should wear self-contained
                          breathing apparatus.
Hazardous Products of Combustion: Irritating vapors. Oxides of carbon
Unusual Fire/Explosion Hazards:  None.


Lower Explosive Limit:    1.0:  Octanol
Upper Explosive Limit:    8.0:  Octanol


6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:   Maintain good ventilation. Take up with an inert
                    absorbent.
                    Store in a closed waste container until disposal.


7. HANDLING AND STORAGE
Storage:            Store below 100 degrees F. Keep in cool and dark place.
                    Avoid direct sunlight.
Handling:           Avoid prolonged skin contact. Keep away from eyes.


8. EXPOSURE CONTROLS/PERSOANL PROTECTION
Eyes:          Safety glasses
Skin:          Rubber or plastic gloves
Ventilation:   General: local exhaust ventilation as necessary to
               control any air contaminants to within their exposure limits (or 
               to the lowest feasible levels when limits have not been          
             established) during the use of this product.
Respiratory Protection:   An approved respirator (i.e.NIOSH, etc.) should be
               worn when exposures are expected to exceed the applicable limits.


9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:               White paste
Odor:                     MILD
Boiling Point:            >300 degrees C.
pH:                       Does not apply
Solubility in Water:      Insoluble
Specific Gravity:         1.2
VOC Content(Wt.%):        10% by weight
Vapor Pressure:           Not determined
Vapor Density (Air=1):    Heavier than air
Evaporation Rate:         Not Determined


10. STABILITY AND REACTIVITY
Chemical Stability:       Stable at normal conditions
Hazardous Polymerization: WILL NOT OCCUR
Incompatibilities:        Metal salts, heat and amines.
Conditions to Avoid:      Heat
Hazardous Products of Combustion:  Irritating vapors. Oxides of carbon.


11. TOXICOLOGICAL INFORMATION
See Section 3

12. ECOLOGICAL INFORMATION
No data available


13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:  Disposal should  be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not a RCRA Hazardous Waste Material


14. TRANSPORTATION INFORMATION
DOT  (49CFR 172)
Domestic Ground Transport
      DOT Shipping Name:     Unrestricted
      Hazard Class:          None
      UN/ID Number:          None
      Marine Pollutant:      None


   IATA
      Proper Shipping Name:  Not regulated
      Class or Division:     None
      UN/NA Number:          None


   IMDG
      Proper Shipping:      Unrestricted
      Hazard Class:         None
      UN Number:            None


15. REGULATORY INFORMATION
SARA 313 Chemicals:  The following component(s) is listed as a SARA Section
                     313 Toxic Chemical.


DIMETHYLBENZYL HYDROPEROXIDE


CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.


TSCA Inventory Status:
Listed on Inventory:  YES All components of this product are listed (or
exempt) on the EPA TSCA inventory.


16. OTHER INFORMATION
Estimated NFPA Rating:         Health 2, Flammability 1, Reactivity 1
Estimated HMIS Classification: Health 2, Flammability 1, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.


Prepared By:    Denise Boyd, Health and Safety Manager    
                Revision Date: August/14/2007
Company:        Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA  06106
                Revision   1
                Number:

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.