MSDS 9111

Permatex, Inc.
10 Columbus Blvd.
Hartford, Ct  06106  USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                     MATERIAL SAFETY DATA SHEET

1. PRODUCT IDENTIFICATION
Product Name:  HIGH STRENGTH THREADLOCKER RED GEL 5 GR
Item No:       27005
Product Type:  Anaerobic


2. COMPOSITION/INFORMATION ON INGREDIENTS
Component           Weight%           ACGIH TLV: TWA         OSHA PEL:
PolyGlycol          50-70               Not Listed          Not Listed
Dimethacrylate
25852-47-5


Polyester Resin     20-40               Not Listed          Not Listed
Mixture

Treated Silicon     1-10                10 mg/m3            10 mg/m3
Dioxide                               total dust TLV        total dust
Synthetic, Crystalline-Free
67762-90-7


Dimethylbenzyl       <4                 Not Listed          Not Listed
Hydroperoxide
80-15-9


Propylene Glycol     <3                 Not Listed          Not Listed
57-55-6

Saccharin          0.5-5.0              10 mg/m3            Not Listed
81-07-2                               nuisance dust


3. HAZARDS IDENTIFICATION
Toxicity:      May cause eye and skin irritation. At elevated temperatures
               may cause irritation of the respiratory tract. Irritates
               mucous membranes. Ingestion may irritate digestive tract and     
          cause nausea, vomiting and diarrhea. High concentrations may          
     cause central nervous system (CNS) depression. May cause skin
               sensitization. Note: This product does not contain
               microcrystalline silica.
Primary Routes of Entry: Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure: Repeated skin contact may cause allergic skin
               reactions. Skin redness. Ingestion may cause nausea and
               vomiting. Inhalation overexposure may cause irritation,
               coughing and flu-like symptoms. May cause pain, redness
               or swelling of the eyes and excessive blinking and tear
               production.


Component      Weight%          NTP               ACGIH             IARC
                                                Carcinogens
Saccharin     0.5-5.0     Delisted April 2000                     Group 3:
81-07-2                                                          Vol 73, 1999


Medical Conditions Recognized as     Preexisting skin disorders.
Being Aggravated by Exposure:


4. FIRST AID MEASURES
Ingestion:     If swallowed, DO NOT induce vomiting.  Keep individual calm.
               Obtain medical attention.
Inhalation:    Move to fresh air in case of accidental inhalation of vapors.
               Obtain medical attention.
Skin Contact:  Wash off with soap and water. If skin irritation persists,
               call a physician.
Eye Contact:   In case of contact, immediately flush eyes with plenty of
               water for at least 15 minutes and get medical attention if
               irritation persists.


5. FIRE FIGHTING MEASURES
Flash Point (degrees F/C):            >200 degrees F
Recommended Extinguishing Media:      Water fog, carbon dioxide, foam,
                                      dry chemical.
Special Fire-Fighting Procedures:     Firefighters should wear self-
                                      contained breathing apparatus.
Hazardous Products of Combustion:     Irritating vapors.
Unusual Fire/Explosion Hazards:       Closed containers may rupture or
                                      explode when exposed to extreme heat

Lower Explosive Limit:          Not determined
Upper Explosive Limit:          Not determined


6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:         Maintain good ventilation. Take up with an inert
                          absorbent. Store in a closed waste container until    
                      disposal

7. HANDLING AND STORAGE
Storage:             Store below 100 degrees F.
Handling:            Avoid prolonged skin contact. Keep away from eyes.


8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:                Safety glasses
Skin:                Rubber or plastic gloves.
Ventilation:         General: local exhaust ventilation as necessary to
                     control any air contaminants to within their exposure
                     limits (or to the lowest feasible levels when limits have
                     not been established) during the use of this product.
Respiratory Protection:   An approved respirator (i.e.NIOSH, etc.) should be
                     worn when exposures are expected to exceed the applicable  
                   limits.

9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:               Red gel
Odor:                     MILD
Boiling Point:            >150 degrees C
pH:                       Does not apply
Solubility in Water:      Insoluble
Specific Gravity:         1.1
VOC Content(Wt.%):        <2% by weight
Vapor Pressure:           Not determined
Vapor Density (Air=1):    Heavier than air
Evaporation Rate:         Not Determined


10. STABILITY AND REACTIVITY
Chemical Stability:       Stable at normal conditions
Hazardous Polymerization: WILL NOT OCCUR.
Incompatibilities:        Strong oxidizers, free radical initiators, inert
                          gases
Conditions to Avoid:      Heat
Hazardous Products of Combustion:   Irritating vapors

11. TOXICOLOGICAL INFORMATION
See Section 3

12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal:  Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not a RCRA Hazardous Waste Material

14. TRANSPORTATION INFORMATION
DOT  (49CFR 172)
Domestic Ground Transport
      DOT Shipping Name:   Unrestricted
      Hazard Class:        None
      UN/ID Number:        None
      Marine Pollutant:    None


IATA
      Proper Shipping Name:  Not regulated
      Class or Division:     None
      UN/NA Number:          None
IMDG
      Proper Shipping:       Unrestricted
      Hazard Class:          None
      UN Number:             None


15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section
313 Toxic Chemical.

DIMETHYLBENZYL HYDROPEROXIDE


CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.

TSCA Inventory Status:
Listed on Inventory:  YES All components of this product are listed (or
exempt) on the EPA TSCA inventory.

16. OTHER INFORMATION
Estimated NFPA Rating:         Health 2, Flammability 1, Reactivity 1
Estimated HMIS Classification: Health 2, Flammability 1, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.


Prepared By:   Denise Boyd, Health and Safety Manager
               Revision Date: July/26/2007
Company:       Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106
               Revision 1
               Number:

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.