![]() |
![]() |
![]() |
|
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 9110 -- [Back] | |||
|
MSDS 9110 9110: Disc Brake Caliper Lube 8 Oz [1]9110-4: Disc Brake Caliper Lube 8 Oz [6] (DISCONTINUED) MSDS Last updated: 01/21/2010
Permatex, Inc.
10 Columbus Blvd.
Hartford Ct 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585
Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product name: ULTA DISC BRAKE CLAIPER LUBE 8FL.
OZ
Item No: 24110
Product Type: Lubricant
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Weight% ACGIH; TLV-TWA OSHA PEL:
SYNTHETIC BASE >90 Not listed Not listed
OILS
TRADE SECRET
3. HAZARDS IDENTIFICATION
Toxicity: May cause eye and skin irritation.
Primary Routes of entry: Eye and skin contact, ingestion,
inhalation
Signs and Symptoms of Exposure: Overexposure may cause eye and skin
redness.
Medical Conditions Recognized as Preexisting skin disorders.
Being Aggravated by Exposure:
4. FIRST AID MEASURES
Ingestion: If swallowed, DO NOT induce
vomiting. Keep individual calm.
Obtain medical attention.
Inhalation: Move to fresh air in case of
accidental inhalation of vapours.
If signs of irritation or toxicity
occur seek medical attention.
Skin Contact: Remove contaminated clothing. Wash
area with soap and water. If
irritation persists, seek medical
attention.
Eye Contact: In case of contact, immediately
flush eyes with plenty of water for
at least 15 minutes and get medical
attention if irritation persists.
5. FIRE FIGHTING MEAURES
Flash Point F(C): >500F COC
Recommended Extinguishing Media: Carbon Dioxide, Dry Chemicals,
Foam.
Special Fire-Fighting Procedures: Treat as oil fire. Firefighters
should wear self-contained
breathing apparatus.
Hazardous Products of Combustion: Oxides of carbon
Unusual Fire/Explosion Hazards: None
Lower Explosive Limit: Not determined.
Upper Explosive Limit: Not determined.
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures: Maintain good ventilation. Take up
with an inert absorbent. Store in a
closed waste container until
disposal.
7. HANDLING AND STORAGE
Storage: Store away from heat
Handling: Avoid contact with skin and eyes.
Wash thoroughly after handling.
Product may cause surfaces to
become slippery.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes: Safety glasses.
Skin: Neoprene or nitrile gloves
recommended.
Ventilation: General ventilation is usually
adequate.
Respiratory Protection: Not normally necessary.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Green semi-solid
Odor: MILD
Boiling Point: Not determined
pH: Does not apply
Solubility in Water: Insoluble
Specific Gravity: 0.89
VOC Content (Wt. %) None
Vapor Pressure: Not Determined
Vapor Density (Air=1): >1 (air=1)
Evaporation Rate: <1 (butyl acetate=1)
10. STABILITY AND REACTIVITY
Chemical Stability: Stable at normal conditions
Hazardous Polymerization: WILL NOT OCCUR.
Incompatibilities: Strong oxidizers
Conditions to Avoid: Welding
Hazardous Products of Combustion: Oxides of carbon
11. TOXICOLGOICAL INFORMATION
See Section 3
12.ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be me made in
accordance with federal, state and
local regulations.
US EPA Waste Number: NH-Not a RCRA Hazardous Waste
Material
14. TRANSPORTATION INFORMATION
DOT (49CRF 172)
Domestic Ground Transport
DOT Shipping Name: Unrestricted
Hazard Class: None
UN/ID Number: None
Marine Pollutant: None
IATA
Proper Shipping Name: Unrestricted
Class or Division: None
UN/ID Number: None
IMDG
Proper Shipping: Unrestricted
Hazard Class: None
UN Number: None
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA
Section 313 Toxic Chemical.
NONE
CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.
TSCA Inventory Status:
Listed on Inventory: YES all components of this product are listed (or
exempt) on the EPA TSCA inventory.
16. OTHER INFORMATION
Estimated NFPA Rating:
HEALTH 1, FLAMMABILITY 1, INSTABILITY 1.
Estimated HMIS
Classification:
HEALTH 1, FLAMMABILITY 1, PHYSICAL HAZARD 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.
Prepared By: Denise Boyd, Manager-Environmental,
Health & Safety
Company: Permatex. Inc.
10 Columbus Blvd.
Hartford, CT USA 06106
Telephone No.: 1-87-Permatex (877) 376-2839
Revision Date: May/27/2008
Revision Number: 1
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |