MSDS 9104

Permatex, Inc.
10 Columbus Blvd.
Hartford, Ct 06106  USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585


                      MATERIAL SAFETY DATA SHEET


1. PRODUCT IDENTIFICATION

Product Name:  PERMANENT STRENGTH THREAD LOCKER RED 50ML
Item No:       26250
Product Type:  Anaerobic


2. COMPOSITION/INFORMATION ON INGREDIENTS

Component                     Weight %    ACGIH TLV: TWA       OSHA PEL:
PolyGlycol Dimethacrylate      60-80       Not Listed          Not Listed
25852-47-5

Polyester Resin                20-40       Not Listed          Not Listed
Mixture

Dimethylbenzyl                  <3         Not Listed          Not Listed
Hydroperoxide
80-15-9

Polyethylene Homopolymer        <3         Not Listed          Not Listed
9002-88-4


3. HAZARDS IDENTIFICATION

Toxicity:      At elevated temperatures may cause irritation of the
               respiratory tract. Irritates mucous membranes. Ingestion may     
               irritate digestive tract and cause nausea, vomiting and diarrhea.
              High concentrations may cause central nervous system (CNS)        
             depression. May cause eye and skin irritation. May cause skin      
            sensitization. Note: This product does not contain               
               microcrystalline silica.
Primary Routes of Entry:  Eye and skin contact, ingestion, inhalation.
Signs and Symptoms of Exposure: Repeated skin contact may cause allergic skin
               reactions. Skin redness. Ingestion may cause nausea and vomiting.
               Inhalation overexposure may cause irritation, coughing and       
               flu-like symptoms. May cause pain, redness or swelling of the    
             eyes and excessive blinking and tear production.

Medical Conditions Recognized as     Preexisting skin disorders.
Being Aggravated by Exposure:


4. FIRST AID MEASURES

Ingestion:     If swallowed, DO NOT induce vomiting. Keep individual calm.
               Obtain medical attention.
Inhalation:    Move to fresh air in case of accidental inhalation of
               vapors. Obtain medical attention.
Skin Contact:  Wash off with soap and water. If skin irritation persists,
               call a physician.
Eye Contact:   In case of contact, immediately flush eyes with plenty of
               water for at least 15 minutes and get medical attention if
               irritation persists.


5. FIRE FIGHTING MEASURES

Flash Point (F/C degrees):           >200 degrees F
Recommended Extinguishing Media:     Water fog, carbon dioxide, foam, dry
                                     chemical.
Special Fire-Fighting Procedures:    Firefighters should wear self-
                                     contained breathing apparatus. Water spray 
                                    may be ineffective on flames but should be  
                                   used to keep fire-exposed containers cool.
Hazardous Products of Combustion:    Oxides of carbon
Unusual Fire/Explosion Hazards:      Closed containers may rupture or explode
                                     when exposed to extreme heat.
                                     May polymerize exothermically.
                                     
Lower Explosive Limit:          Not determined
Upper Explosive Limit:          Not determined


6. ACCIDENTAL RELEASE MEASURES

Spill Procedures:         Maintain good ventilation. Take up with an inert
                          absorbent. Store in a closed waste container until    
                          disposal.


7. HANDLING AND STORAGE

Storage:       Do not store at or below 32 degrees F. as inhibitor can
               separate as a solid. Prevent moisture contact.
               Store in tightly closed containers away from heat,
               sparks, open flame, oxidizers, radiation and other initiators.
               Prevent contamination by foreign materials.
               Use only non-sparking tools.
Handling:      Avoid prolonged skin contact. Keep away from eyes.


8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Eyes:          Safety glasses
Skin:          Rubber or plastic gloves.
Ventilation:   General: local exhaust ventilation as necessary to
               control any air contaminants to within their exposure  limits
               (or to the lowest feasible levels when limits have not
               been established) during the use of this product.
Respiratory Protection:   An approved respirator (i.e.NIOSH,etc.) should be
               worn when exposures are expected to exceed the applicable limits.


9. PHYSICAL AND CHEMICAL PROPERTIES

Appearance:               Red liquid
Odor:                     MILD
Boiling Point:            >200 degrees C
pH:                       Does not apply
Solubility in Water:      Insoluble
Specific Gravity:         1.1
VOC Content(Wt.%):        <2% by weight
Vapor Pressure:           Not determined
Vapor Density (Air=1):    >1
Evaporation Rate:         Not determined


10. STABILITY AND REACTIVITY

Chemical Stability:       Stable at normal conditions
Hazardous Polymerization: MAY OCCUR
Incompatibilities:        Strong oxidizers, free radical initiators,
                          inert gases, Peroxides, Reducing agents, Oxygen       
                          scavengers.
Conditions to Avoid:      Heat
Hazardous Products of Combustion:   Oxides of carbon


11. TOXICOLOGICAL INFORMATION

See Section 3


12. ECOLOGICAL INFORMATION

No data available


13. DISPOSAL CONSIDERATIONS

Recommended Method of Disposal:  Disposal should be made in accordance  with
federal, state and local regulations.
US EPA Waste Number:      NH - Not a RCRA Hazardous Waste Material


14. TRANSPORTATION INFORMATION

DOT  (49CFR 172)
Domestic Ground Transport
      DOT Shipping Name:     Unrestricted
      Hazard Class:          None
      UN/ID Number:          None
      Marine Pollutant:      None

   IATA
      Proper Shipping Name:  Not regulated
      Class or Division:     None
      UN/NA Number:          None

   IMDG
      Proper Shipping:       Unrestricted
      Hazard Class:          None
      UN Number:             None


15. REGULATORY INFORMATION

SARA 313 Chemicals:  The following component(s) is listed as a SARA Section
313 Toxic Chemical.

DIMETHYL BENZYL HYDRO PEROXIDE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.

TSCA Inventory Status:
Listed on Inventory:  YES All components of this product are listed (or
exempt) on the EPA TSCA inventory.


16. OTHER INFORMATION

Estimated NFPA Rating:         Health 2, Flammability 1, Reactivity 1
Estimated HMIS Classification: Health 2, Flammability 1, Physical Hazard 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.


Prepared By:     Denise Boyd, Health and Safety Manager
Company:         Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106
Revision Date:   November/15/2007
Revision Number: 1

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2010 Imperial Supplies LLC Questions or comments? Contact us.