MSDS 9100

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: +01-813-248-0585


                    Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product Name:            MEDIUM STRENGTH THREADLOCKER BLUE GEL 10 GR
Item No:                 24010
Product Type:            Anaerobic

2. COMPOSITION/INFORMATION ON INGREDIENTS
Component                    Weight%          ACGIH; TLV-TWA       OSHA PEL:
                   
POLYGLYCOL DIMETHACRYLATE    30-50            Not Listed          Not Listed
25852-47-5
          
POLYESTER RESIN              20-40            Not Listed          Not Listed
MIXTURE

BENZOATE ESTERS              10-30            Not Listed          Not Listed
MIXTURE
                                                         
TREATED SILICON DIOXIDE,     <10              10 mg/m3            10 mg/m3
SYNTHETIC, CRYSTALLINE-FREE                                       total dust
67762-90-7
                      
DIMETHYLBENZYL               <3               Not Listed          Not Listed
HYDROPEROXIDE
80-15-9
                     
PROPYLENE GLYCOL             <3               Not Listed          Not Listed
57-55-6
                                             
TITANIUM DIOXIDE           0.1-1.0            10 mg/m3           15 mg/m3 TWA
13463-67-7                                                       (total dust)


3. HAZARDS IDENTIFICATION
Toxicity:         May cause eye and skin irritation. At elevated temperatures   
                  may cause irritation of the respiratory tract.
                  Irritates mucous membranes. Ingestion may irritate digestive  
                  tract and cause nausea, vomiting and diarrhea. High           
                  concentrations may cause central nervous system (CNS)         
                depression. May cause skin sensitization. 
                  Note: This product does not contain microcyrstalline silica.
Primary Routes of Entry:  Eye and skin contact, ingestion, inhalation
Signs and Symptoms of Exposure: Repeated skin contact may cause allergic skin   
                  reactions. Skin redness. Ingestion may cause nausea and
                  vomiting. Inhalation overexposure may cause irritation,       
                  coughing and flu-like symptoms. May cause pain, redness or    
                  swelling of the eyes and excessive blinking and tear          
                 production.

Component            Weight%         NTP             ACGIH             IARC
                                                   Carcinogens
TITANIUM DIOXIDE     0.1-1.0     male rat-negative,     A4           Group 2B;
13463-67-7                       female rat-negative               Vol 93 2006:
                                 male mice-negative               Vol 47, 1989  
                                 female mice-negative    
                
Medical Conditions Recognized as           Preexisting skin disorders.
Being Aggravated by Exposure:

4. FIRST AID MEASURES
Ingestion:              If swallowed, DO NOT induce vomiting. Keep individual   
                        calm. Obtain medical attention.
Inhalation:             Move to fresh air in case of accidental inhalation of
                        vapors. Obtain medical attention.
Skin Contact:           Wash off with soap and water. If skin irritation        
                        persists, call a physician.
Eye Contact:            In case of contact, immediately flush eyes with plenty  
                        of water for at least 15 minutes and get medical
                        attention if irritation persists.


5. FIRE FIGHTING MEASURES
Flash Point °F(C°):     >200 degrees F
Recommended Extinguishing Media:   Water fog, carbon dioxide, foam, dry
                        chemical.
Special Fire-Fighting Procedures:  Firefighters should wear self-contained 
                       breathing apparatus..
Hazardous Products of Combustion:  Irritating vapors
Unusual Fire/Explosion Hazards: Closed containers may rupture or explode when
                       exposed to extreme heat.

Lower Explosive Limit: Not determined
Upper Explosive Limit: Not determined
                          
6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:  Maintain good ventilation. Take up with an inert absorbent.
                   Store in a closed waste container until disposal.


7. HANDLING AND STORAGE
Storage:           Store below 100 degrees F.
Handling:          Avoid prolonged skin contact. Keep away from eyes.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:              Safety glasses.
Skin:              Neoprene or nitrile gloves recommended.
Ventilation:       General; local exhaust ventilation as necessary to control
                   any air contaminants to within their exposure
                   limits (or to the lowest feasible levels when limits have
                   not been established) during the use of this product.
Respiratory Protection:  An approved organic vapor respirator should be worn    
                   when exposures are expected to exceed the applicable limits.


9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:             Blue gel
Odor:                   MILD
Boiling Point:          >150°C
pH:                     Does not apply
Solubility in Water:    Insoluble
Specific Gravity:       1.1
VOC Conten(Wt.%):       <2% by weight
Vapor Pressure:         Not determined
Vapor Density (Air=1):  Heavier than air
Evaporation Rate:       Not Determined

10. STABILITY AND REACTIVITY
Chemical Stability:        Stable at normal conditions
Hazardous Polymerization:  WILL NOT OCCUR.
Incompatabilities:         Strong oxidizers, free radical initiators,
                           inert gases
Conditions to Avoid:       Heat
Hazardous Products of Combustion:  Irritating vapors


11. TOXICOLOGICAL INFORMATION
See Section 3

12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not a RCRA Hazardous Waste Material


14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
     DOT Shipping Name:  Unrestricted
     Hazard Class:       None
     UN/ID Number:       None
                                         
IATA
     Proper Shipping Name:  Not regulated
     Class or Division:     None
     UN/ID Number:          None
                             
       
IMDG
     Proper Shipping:       Unrestricted
     Hazard Class:          None
     UN Number:             None
      
     Marine Pollutant:      None
     
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313
Toxic Chemical.

DIMETHYLBENZYL HYDROPEROXIDE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.

TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.

16. OTHER INFORMATION
Estimated NFPA Rating:           HEALTH 2, FLAMMABILITY 1 , REACTIVITY 1.
Estimated HMIS Classification:   HEALTH 2, FLAMMABILITY 1, PHYSICAL HAZARD 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.


Prepared By:  Denise Boyd, Manager-Environmental, Health & Safety
              Revision Date: July/26/2007
Company:      Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106           
              Revision 1
              Number:

Telephone No:  1-87-Permatex (877) 376-2839




                                

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2010 Imperial Supplies LLC Questions or comments? Contact us.