![]() |
![]() |
![]() |
|
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 7570 -- [Back] | |||
|
MSDS 7570 7570: Blue Silicone 3OZ [6]7571: Blue Silicone 10.3 [12] (DISCONTINUED) MSDS Last updated: 03/14/2005
MATERIAL SAFETY DATA SHEET
DYNATEX®
350 RING ROAD ELIZABETHTOWN, KY 42701
PH. (270) 769-5557 FAX: (270) 769-6418
BLUE SILICONE GASKET MAKER
PART NOS. 41206, 49206, 49296
SECTION 1 - IDENTITY INFORMATION
Description: RTV Blue Silicone Gasket Maker
Chemical Family; RTV Silicone
SECTION II - HAZARDOUS INGREDIENTS
INGREDIENT CAS NO. EXPOSURE LIMITS WT %
--------------------------------------------------------------------------------
Methyltriacetoxysilane 004253343 See Acetic Acid Comments 2
Ethyltriacetoxysilane 017689779 See Acetic Acid Comments 2
Silica, Amorphous 007631869 Observe Particulates Limits. 10
OSHA PEL: TWA 15 mg/m3
Total dust, 5 mg/m3 Respirable
Fraction. ACGIH TLV: TWA
10 mg/m3 Total Dust.
COMMENT: Observe Limits for Acetic Acid, Formed during Curing on Exposure to
Water of Humid Air. OSHA PEL: TWA 10 PPM. ACGIH TLV; TWA 10 PPM, STEL 15 PPM.
SECTION III - PHYSICAL AND CHEMICAL CHARACTERISTICS
Boiling Point; N/A
Freezing/Melting Point: N/D
Vapor Pressure ( @ 25? C N/A
Vapor Density: N/A
Solubility in Water: None
Specific Gravity 25? C: 1.03
Volatile Content; N/A
Viscosity: N/A
pH: N/A
Odor, Appearance, Color; Acetic acid-like, paste, blue
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Closed Cup): N/A (Solid)
Auto Ignition Temperature: N/D
Flammability Limits in Air: N/D
Extinguishing Media: Carbon dioxide (CO2). Water.
Water fog (or spray). Dry chemical. Foam.
Unsuitable Extinguishing Media: None.
Special Fire Fighting Procedures: Self-contained breathing apparatus and
protective clothing should be worn in
fighting fires involving chemicals. If large
amount is involved evacuate area.
Unusual Fire Hazards: None.
Hazardous Decomposition Products: Thermal breakdown of this product during
fire or very high heat conditions may evolve
the following hazardous decomposition
products: silicon dioxide. Carbon oxides and
traces of incompletely burned compounds.
Formaldehyde.
COMMENTS: N/D - Not Determined. Product is considered a Solid for DOT Purposes
And Flash Point is not applicable.
SECTION V - HEALTH HAZARD DATA
ACUTE EFFECTS:
Eye: Direct contact irritates moderately with redness
and swelling.
Skin: A single short exposure (less than 24 hours) may
irritate. Repeated prolonged contact (24 to 48
hours) may irritate moderately.
Inhalation: Vapor overexposure may irritate eyes, nose and
throat.
Oral: Small amounts transferred to the mouth by fingers
during use, etc. should not injure. Swallowing
large amounts may cause digestive discomfort.
REPEATED EXPOSURE EFFECTS:
Skin: None known.
Inhalation: None known.
Oral: None known.
SPECIAL HAZARDS:
Carcinogens: None known.
Teratogens: None known.
Mutagens: None known.
Reproductive Toxins: None known.
Sensitizers: None known.
COMMENTS: When Heated to Temperatures Above 150? C in the Presence of Air,
Product Can Form Formaldehyde Vapor. Formaldehyde is a Potential Cancer Hazard,
a Known Skin and Respiratory Sensitizer, and an Irritant to the Eyes, Nose,
Throat, Skin and Digestive System. Safe Handling Conditions may be maintained by
Keeping Vapor Concentrations within the OSHA Permissible Exposure Limit for
Formaldehyde.
EMERGENCY AND FIRST AID PROCEDURES;
Eyes: Flush eyes immediately with water for at least
15 minutes. Seek medical assistance.
Skin: Remove from skin and wash thoroughly with
soap and water or waterless cleanser. Get
medical attention if irritation or other ill effects
develop or persist.
Inhalation; Remove to fresh air.
Oral: No first aid should be needed.
Comments: Treat According to Person's Condition and Specifics of Exposure.
SECTION VI - REACTIVITY DATA
Chemical Stability: Stable.
Hazardous Polymerization: Will not occur.
Conditions to Avoid: None.
Materials to Avoid: Oxidizing material can cause a reaction.
Comments: Water, Moisture, or Humid Air Can Cause Hazardous Vapors to Form.
SECTION VII - ACCIDENTAL RELEASE MEASURES
Containment/Clean-Up: Disposal of collected product, residues and
cleanup materials may be governmentally
regulated. Observe all applicable local, state,
and federal waste management regulations.
Scrape up and contain for salvage or disposal.
Observe all personal protection equipment
recommendations. Local, state and federal
reporting requirements may apply to spills or
releases of this material into the environment.
SECTION VIII - HANDLING AND STORAGE
Handling: No special precautions.
Storage: Keep container closed and store away from water
or moisture.
SECTION IX - EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS:
Local Exhaust: Recommended
General Ventilation: Recommended
PERSONAL PROTECTIVE EQUIPMENT FOR ROUTINE HANDLING:
Eyes: Use proper protection - safety glasses, as a
minimum.
Skin: Washing at mealtime and end of shift is adequate.
Suitable Gloves: No special protection needed.
Inhalation: Use respiratory protection unless adequate local
exhaust ventilation is provided or air sampling
data show exposures are within recommended
exposure guidelines. Industrial hygiene personnel
can assist in judging the adequacy of existing
engineering controls.
Suitable Respiratory: Organic vapor/dust/mist type.
PERSONAL PROTECTIVE EQUIPMENT FOR SPILLS:
Eye: Use proper protection - safety glasses as a
minimum.
Skin; Washing at mealtime and end of shift is adequate.
Inhalation/Suitable Respirator: Use respiratory protection unless
adequate local exhaust ventilation is provided or air sampling data
show exposures are within recommended exposure guidelines. Industrial hygiene
personnel can assist in judging the adequacy of existing engineering controls.
Precautionary Measures: Avoid eye contact. Avoid breathing vapor. Keep
container closed. Use reasonable care.
COMMENTS: Product Evolves Acetic Acid (HOAC) when exposed to Water or Humid
Air. Provide Ventilation during Use to Control HOAC within Exposure Guidelines
or Use Respiratory Protection.
Contents of This MSDS Comply with the OSHA Hazard Communication Standard 29CFR
1910.1200.
TSCA Status: All Chemical substances Found in This Product Comply with the Toxic
Substance Control Act Inventory Reporting Requirements.
SECTION X - REGULATORY INFORMATION
Proper Shipping Name (49CFR 172.101): None
D.O.T. Hazard Name (49CFR 172.101): None
D.O.T. ID No. (49CFR 172.101): None
D.O.T. Hazard Class (49CFR 172.101): None
RCRA Hazard Class (40CFR 261) (if discarded):None
E.P.A. Priority Pollutants (40CFR 122.53): None
SECTION XI - HAZARD COMMUNICATION CODES
NFPA RATINGS (National Fire Protection Association)
Health: 1
Flammability: 1
Reactivity: 1
The information contained herein is based on data considered accurate. However,
no warranty is expressed or implied regarding the accuracy of the data or the
results to be obtained from the use thereof. Because the information contained
herein may be applied under conditions beyond our control, we assume no
responsibility for its use.
Rev. 2/08/03
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |