Start an Order |
|
|
|
| Start an Order |
|||
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 7549 -- [Back] | |||
|
MSDS 7549 7549: Dynacopper Silicone 3.35oz [6]MSDS Last updated: 12/31/2009
IMPERIAL SUPPLIES LLC MSDS SHEET FOR 7549
Product Dynatex 47101 DynaCopper RTV Silicone Gasket Mater - L/V
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Trade Name of this Product Dynatex 47101 dynaCopper RTV Silicone Gasket Mater
- L/V
Synonyms: 2596447101
MSDS ID DYN47101
Manufacturer Dynatex Inc.
350 Ring Rd
Elizabethtown, KY 42701
Phone Number (270) 769-3385
Emergency Phone CHEMTREC (800) 424-9300
Revision Date 8/28/2009
Health 1
Fire 1
Reactivity 0
2. COMPOSITION AND INFORMATION ON INGREDIENTS
Ingredient CAS Number Weight % ACGIH TLV PEL STEL
Calcium Carbonate 1317-65-3 15%-50% 15 mg/m 10 mg/m
total dust total dust
Amorphous fumed 112945-52-5 3%-6% 10 mg/m 6mg/m
silica
Methyl Oximino 22984-54-9 1%-5%
Silane
Vilyn Oximino Silane 2224-33-1 3%-Max
3. HAZARD IDENTIFICATION
Eye Contact Direct eye contact irritates slightly with redness and
swelling.
Inhalation Vapor overexposure may cause drowsiness, injure blood,
liver and may irritate eyes, nose and throat.
Ingestion Small amounts transferred to the mouth by fingers during
use, etc., should not injure. Swallowing large amounts
may injure slightly.
Skin Contact A single short term exposure (less than 24 hours) may
irritate. Repeated prolonged contact (24 to 48 hours) may
irritate moderately. Product contains oximes which are
possible skin sensitizers.
Symptoms of No known applicable information
Overexposure
Existing Conditions No known applicable information
Aggravated by
Exposure
Comment
Methyl ethyl ketoxime MEKO) is formed upon contact with water or humid air.
Male rodents exposed to MEKO vapor throughout their lifetime developed liver
tumors. Since many commonly used chemicals cause liver tumors in rats and
mice, additional testing is planned by the MEKO supplier to determine any
relevance to humans. Until more data is known, exposure levels should be
maintained as low as possible.
4. FIRST AID INFORMATION
Eye Contact Immediately flush eyes with water for at least 15 minutes. Seek
medical attention.
Skin Contact Remove from skin and wash thoroughly with soap and water or
waterless cleanser. Get medical attention if irritation or other
ill effects develop or persist.
Inhalation Remove to fresh air. No first aid should be needed.
Ingestion No first aid should be needed
Comments
Treat according to person's condition and specifics of exposure.
5. FIRE FIGHTING MEASURES
Flash Point Not applicable
Auto-ignition Temperature Not determined
Flammability Limits in Air Not determined
Extinguishing Media On large fires use dry chemical, foam, or water
spray. On small fires use carbon dioxide, dry
chemical or water spray. Water can be used to
cool fire exposed containers.
Special Fire Fighting Self-contained breathing apparatus and
Procedures protective clothing should be worn when fighting
large fires involving chemicals. Determine the
need to evacuate or isolate the area according
to your local emergency plan. Use water spray to
keep fire exposed containers cool.
Unusual Fire and Explosion None Known
Hazards
6. ACCIDENTAL RELEASE MEASURES
Steps to be taken in case of spill or release
Determine weather to evacuate or isolate the area according to your local
emergency plan. Observe all personal protection equipment recommendations
described in Sections 5 and 8. For large spills, provide diking or other
appropriate containment to keep material from spreading. If diked material can
be pumped, store recovered material in appropriate container. For small
spills, wipe up or scrape up and contain for salvage or disposal. Clean area
as appropriate since spilled material, even in small quantities, may present a
slip hazard. Final cleaning may require the use of steam, solvents or
detergents. Dispose of saturated absorbent or cleaning materials
appropriately, since spontaneous heating may occur.
Local, state and federal laws and regulations may apply to released and
disposal of this material, as well as those material and items employed in the
cleanup of released. You will need to determine which federal, state and local
laws and regulations are applicable. Sections 13 and 15 of this MSDS provide
information regarding certain federal and state requirements.
7. HANDLING AND STORAGE
Handling Avoid eye contact. Avoid skin contact. Avoid breathing vapor. Keep
container closed. Do not take internally. Use reasonable care.
Storage Keep container closed and store in a cool, well ventilated area,
away from water or moisture.
Other Product evolves methyl ethyl ketoxime (MEKO) when exposed to water
Precautions or humid air. Provide ventilation during use to control MEKO within
the exposure guidelines or use respiratory protection.
8. EXPOSURE CONTROLS AND PERSONAL PROTECTION
Eye Protection Safety goggles or glasses with side shields are
recommended.
Skin Protection Wash at mealtimes and end of shift. Contaminated clothing
and shoes should be removed as soon as practical and
thoroughly cleaned before reuse. Chemical protective
gloves are recommended.
Suitable Gloves:
Silver Shield 4H
Respiratory No respiratory protection should be needed with good
Protection local ventilation.
Precautionary Avoid eye contact. Avoid skin contact. Avoid breathing
Measures vapor. Keep container closed. Do not take internally.
Use reasonable care.
Comment Product evolves methyl ethyl ketoxime (MEKO) when
exposed to water or humid air. Provide ventilation
during use to control methyl ethyl ketoxime within the
exposure guidelines or use respiratory protection.
Note These precautions are for room temperature handling. Use
at elevated temperature or aerosol/spray applications
may require added precautions. For further information
regarding aerosol inhalation toxicity, please refer to
the guidance document regarding the use of
silicone-based materials in aerosol applications that
has been developed by the silicone industry
(www.SEHSC.com).
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State Paste
Specific Gravity 1.41
Color/Appearance Copper
Odor Slight
pH Not applicable
Boiling/Cond. Point Not applicable
Melting/Freezing Point Not applicable
Solubility Negligible in water
Viscosity Not applicable
Vapor Density Not applicable
Vapor Pressure Not applicable
Note: The above information is not intended for use in preparing product
specifications. Contact Accumetric LLC before writing specifications.
10. STABILITY AND REACTIVITY
Chemical Stability Stable
Hazardous Polymerization Will not occur
Materials to Avoid / Incompatibility Oxidizing material can cause a
reaction. Water, moisture or humid air
can cause hazardous vapors to form.
Conditions to Avoid None known
11. TOXICOLOGICAL INFORMATION
Special Hazard Information on Component
Methyl Oximino Silane (22984-54-9) Possible skin sensitizer
Vinyl Oximino Silane (2224-33-1) Possible skin sensitizer
12. ECOLOGICAL INFORMATION
Environmental Fate and Distribution Complete information is not yet
available.
Environmental Effects Complete information is not yet
available.
Fate and Effects in Waste Water Complete information is not yet
Treatment Plants available.
13. DISPOSAL CONSIDERATION
Waste Disposal Method:
We make no guarantee or warranty of any kind that the use or disposal of this
product complies with all local, state or federal laws. It is also the
obligation of each user of the product mentioned herin to determined and
comply with the requirements of all applicable statutes.
This product is not known to be regulated under RCRA regulations. Disposal of
unused portions of this product and process waste containing this product
should be done only after a careful evaluation and in compliance with all
federal, local and state laws.
14. TRANSPORTATION INFORMATION
DOT Road Shipment Information: Not subject to DOT
Ocean Shipment (IMDG): Not subject to IMDG code
Air Shipment (IATA): Not subject to IATA regulations
15. REGULATORY INFORMATION
The contents of this MSDS comply with the OSHA hazard Communication Standard
29 CFR 1910-1200.
TSCA Status
All chemical substances in this material are included on or exempted from
listing on the TSCA Inventory of Chemical Substances.
SARA Title III Section 302 Extremely Hazardous Substances: None
SARA Title III 304 CERCLA Hazardous Substances: None
SARA Title III Section 312 Hazard Class
Acute: Yes
Chronic: No
Fire: No
Pressure: No
Reactive: No
SARA Title III 313 Toxic Chemicals: None present or none present in regulated
quantities.
California Proposition 65
This product contains the following chemical(s) listed by the State of
California under the Safe Drinking Water and Toxic Enforcement Act of 1986
(Proposition 65) as being known to cause cancer, birth defects or other
reproductive harm:
None known
16. OTHER INFORMATION
Disclaimer
The data contained herein is based upon information that Accumetric LLC
believes to be reliable. Users of this product have the responsibility to
determine that suitability of use and to adopt all necessary precautions to
ensure the safety and protection of property and persons involved in said use.
All statements to suggestions are made without warranty, expressed or implied,
regarding the accuracy of the information, the hazards connected with the use
of the material or the results to be obtained from the use thereof.
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |
