![]() |
![]() |
![]() |
|
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 7542 -- [Back] | |||
|
MSDS 7542 7542: Anaerobic Gasket Maker 50 Ml [2]MSDS Last updated: 03/04/2005
MATERIAL SAFETY DATA SHEET
DYNATEX®
350 RING ROAD ELIZABETHTOWN, KY 42701
PH (270) 769-5557 FAX: (270)769-6418
ANAEROBIC GASKET MAKER
PART NO. 49477
SECTION 1 - IDENTITY INFORMATION
Product Type: Anaerobic Adhesive/Sealant
SECTION II - COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous Component CAS Number %
--------------------------------------------------------------------------------
Dimethacrylate Ester 25852-47-5 65-75
Bisphenol A Fumurate Resin 39382-25-7 20-30
Saccharin 81-07-2 1-3
Polyethylene 9002-88-4 1-3
Amorphous Silica 112945-52-5 0.1-1.0
Cumene Hydroperoxide* 80-15-9 1-3
Organic Acid Trade Secret 0.1-1.0
Dyes Trade Secret 0.03-0.10
*SARA Section 313 Toxic Chemical
Ingredients which have exposure limits
Exposure Limts (TWA) ACGIH (TLV) OSHA (PEL) OTHER
--------------------------------------------------------------------------------
Amorphous Silica 10mg/m3 TWA 6mg/m3 TWA 3mg/m3 TWA
resp dust
Exposure Limits STEL)
SECTION III - HAZARDOUS IDENTIFICATION
Toxicity: Mild eye irritant
Primary Routes of Entry: Eyes, skin
Signs of Exposure; May cause dermatitis on prolonged contact in
sensitive individuals.
Existing Conditions
Aggravated by Overexposure: None known
SECTION IV - FIRST AID MEASURES
Ingestion: Do not induce vomiting. Keep individual calm.
Obtain medical attention.
Inhalation; Does not apply
Skin Contact: Wash affected area with soap and water.
Eye Contact; Flush with warm water. Seek competent medical
attention.
SECTION V - FIRE FIGHTING MEASURES
Flash Point: 150-200 F, Tag Closed Cup
Extinguishing Media: Foam, Dry chemical or Carbon Dioxide
Unusual Fire or Explosion Hazards: None
Special Fire Fighting Procedures: None
Hazardous Products formed by
Fire or Thermal Decomposition: Irritating Organic Vapors
SECTION VI - ACCIDENTAL RELEASE AND DISPOSAL MEASURES
Accidental Spill or Leak: Soak up with inert absorbent. Store in a partly
filled, closed container until disposal.
Disposal Procedures: Incinerate or dispose of in an approved landfill
in accordance with local and EPA regulations.
Not a RCRA hazardous waste.
SECTION VII - HANDLING AND STORAGE
Safe Storage: Store below 100? F.
Handling: Avoid contact with skin and eyes.
SECTION VIII - PROTECTIVE EQUIPMENT
Ventilation: Does not apply.
Respiratory Protection; Not applicable.
Skin: Rubber, polyethylene, or neoprene gloves.
Eye Protection: Safety glasses or goggles with side shields.
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Red liquid
Odor: Mild
Boiling Point; >300? F
Vapor Pressure: <5mmHg @ 20? C
Vapor Density; Approximately 3 (Air = 1)
Evaporation Rate: N/A
Specific Gravity: 1.1
Solubility in Water; Negligible
SECTION X - STABILITY AND REACTIVITY DATA
Stability; Stable
Hazardous Polymerization: Will not occur
Incompatibility: None
SECTION XI - TOXICOLOGICAL INFORMATION
See Section III
SECTION XII - ECOLOGICAL INFORMATION
No Data
SECTION XIII - TRANSPORTATION INFORMATION
Domestic Ground Transport
Proper Shipping Name: Unrestricted (not more than 450 liters)
Combustible Liquid, n.o.s. (more than 450 liters)
Hazard Class or Division: Unrestricted (not more than 450 liters)
Combustible Liquid (more than 450 liters)
Identification Number: None (not more than 450 liters)
NA 1993 (more than 450 liters)
Marine Pollutant: No
SECTION XIV - REGULATORY INFORMATION
CA Proposition 65: This product contains saccharin. Proper usage
necessitates no Proposition 65 warning.
SECTION XV - HAZARD CODE INFORMATION
Hazard NFPA Hazard Code HMIS Hazard Code
--------------------------------------------------------------------------------
Health 1 1
Fire 1 1
Reactivity 1 1
Specific Hazard None Personal protection:
See Section VIII
NFPA is a registered trademark of the National Fire Protection Association.
HMIS is a registered trademark of the National Paint and Coatings Association.
The information contained herein is based on data considered accurate. However,
no warranty is expressed or implied regarding the accuracy of the data or the
results to be obtained from the use thereof. Because the information contained
herein may be applied under conditions beyond our control, we assume no
responsibility for its use.
Rev. 03/07/03
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |