Start an Order |
|
|
|
| Start an Order |
|||
| Home > Products > Chemicals & Paint > MSDS Sheets > MSDS 7540 -- [Back] | |||
|
MSDS 7540 7540: Pipe Sealant W/Teflon 50 Ml [2]MSDS Last updated: 03/14/2005
MATERIAL SAFETY DATA SHEET
DYNATEX ®
350 RING ROAD ELIZABETHTOWN, KY 42701
PH. (270) 769-5557 FAX; (270) 769-6418
PIPE SEALANT WITH PTFE
PART NOS. 49485,49486
SECTION 1 - IDENTITY INFORMATION
Description: Anaerobic Sealant
SECTION II - HAZARDOUS INGREDIENTS
INGREDIENTS CAS # % (OPTIONAL)
--------------------------------------------------------------------------------
Dimethacrylate Ester 25852-47-5 65 to 75
Bisphenol A Fumurate Resin 39382-25-7 20 to 30
Saccharin 81-07-2 1 to 3
Polyethylene 9002-88-4 1 to 3
Amorphous Silica 112945-52-5 0.1 to 1.0
Cumene Hydroperoxide* 80-15-9 1 to 3
Organic Acid Trade Secret 0.1 to 1.0
Dyes: Trade Secret 0.03 to 0.10
Teflon 9002-84-0 1 to 3
*SARA Section 313 Toxic Chemical
Ingredients which have exposure limits
Exposure Limits (TWA) ACGIH (TLV) OSHA (PEL) OTHER
Amorphous Silica 10mg/m3 TWA 6mg/m3 TWA 3mg/m3 TWA
resp. dust
SECTION III - PHYSICAL DATA
Boiling Point: >300? F
Specific Gravity (H20=1): 1.1
Vapor Pressure, (mm Hg); <5 @ 20? C
Vapor Density (AIR=1): Approximately 3
Solubility in Water: Negligible
Evaporation Rate (Butyl Acetate=1): N/A
Appearance and Odor: White paste, mild odor.
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used); 150-200? F (Tag Closed Cup)
Extinguishing Media: Carbon dioxide, foam, and dry chemicals.
Special Fire Fighting Procedures; None.
Unusual Fire and Explosion Hazards: None.
Thermal Decomposition: Irritating organic vapors.
SECTION V - REACTIVITY DATA
Stability: Stable
Incompatibility (Materials to Avoid): None.
Hazardous Polymerization; Will not occur.
SECTION VI - HEALTH HAZARD DATA
Toxicity: Mild eye irritant.
Primary Route(s) of Entry: Eyes, skin.
Signs of Exposure: May cause dermatitis on prolonged contact in
sensitive individuals.
Existing Conditions Aggravated by
Over Exposure: None known.
EMERGENCY AND FIRST AID PROCEDURES:
Skin Contact: Wash affected area with soap and water.
Eye Contact: Flush with warm water. Seek competent
medical attention.
Inhalation; Does not apply.
Ingestion; Do Not induce vomiting. Keep individual calm.
Obtain medical attention.
SECTION VII - ACCIDENTAL RELEASE MEASURES
Steps to be taken in Case of Spill/Leak;
Soak up with inert absorbent. Store in a
partly filled, closed container until disposal.
SECTION VIII - HANDLING AND STORAGE
Safe Storage: Store below 100? F.
Handling: Avoid contact with skin and eyes.
SECTION IX - PROTECTIVE EQUIPMENT
Ventilation; Does not apply.
Respiratory Protection: No applicable.
Skin: Rubber, Polyethylene, or neoprene gloves.
Eye Protection: Safety glasses or goggles with side shields.
Work/Hygienic Practices; Wash hands thoroughly after use.
SECTION X - DISPOSAL CONSIDERATIONS
Disposal Procedures; Incinerate or dispose of in an approved landfill
in accordance with local and EPA regulations.
Not a RCRA hazardous waste.
SECTION XI - REGULATORY INFORMATION
CA PROPOSITION 65:
This product contains saccharin. Proper usage necessitates no
Proposition 65 warning.
SECTION XII - TRANSPORTATION INFORMATION
Domestic Ground Transport:
Proper Shipping Name: Unrestricted (not more that 450 liters)
Combustible liquid, n.o.s. (more than
450 liters)
Hazard Class or Division; Unrestricted (not more than 450 liters)
Combustible liquid (more that 450 liters)
Identification Number; None (not more than 450 liters)
NA 1993 (more than 450 liters)
Marine Pollutant: No
SECTION XIII - HAZARD COMMUNICATION CODES
HMIS® Hazard Code;
Health: 1
Fire: 1
Reactivity: 1
Personal Protection: See Section 9.
NFPA® Hazard Code:
Health: 1
Fire: 1
Reactivity: 1
HMIS® is a registered trademark of the National Paint and Coatings Association
NFPA® is a registered trademark of the National Fire Protection Association
The information contained herein is based on data considered accurate. However,
no warranty is expressed or implied regarding the accuracy of the data or the
results to be obtained from the use thereof. Because the information contained
herein may be applied under conditions beyond our control, we assume no
responsibility for its use.
Rev. 10/25/04
The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance. For more product information by email, click here Imperial Supplies LLC does not provide services and products outside the United States |
Printer-Friendly View
