MSDS 6630

MATERIAL SAFETY DATA SHEET

Environmental Lubricants Manufacturing, Inc.
5526 Nordic Drive
Cedar Falls, Iowa 50613

Moly EP Grease #2
Lubrimatic Part Numbers: 10314

HMIS: Health - 1, Fire - 0, Reactivity - 0, Protection - B

Date Issued: 10/14/2005
Date Revised: 10/31/2008

Emergency Phone Number: (319) 277-9075
CHEMTREC: (800) 424-9300


I. IDENTIFICATION & PHYSICAL DATA

Product Name:                 Moly EP Grease #2                               
Percent Volatile by Volume:   0                                               
Product Class:                Formulated Lubricating Grease                   
Boiling Range:                ND                                              
Manufacturer's I.D.:          MultiPurpose Lithium Grease w/ MoS2             
Vapor Density:                Heavier than air                                
VOC:                          None                                            
Specific Gravity:             0.995                                           
Solubility in Water:          Practically Insoluble                           
Vapor Pressure at 20 C:       <0.5 mm Hg                                      
Evaporation Rate:             Slower Than Butyl Acetate                       
Appearance and Odor:          Silver to Black grease with characteristic      
                              vegetable oil odor                              


II. COMPOSITION/INFORMATION ON INGREDIENTS

              CAS#         OSHA TWA     OSHA STEL    ACGIH STEL   ACGIH TWA   
Soybean Oil   8001-22-7    15 mg/m3     ---          ---          ---         
Fatty Acid    Mixture      ---          ---          ---          ---         
Lithium Soap                                                                  
Molybdenum    1317-33-5    ---          ---          ---          10 mg/m3    
Disulphide                                                                    
Additive      Confidential ---          ---          ---          ---         
Mixture**                                                                     

** This information is being withheld by suppliers as trade secret
--- Not established

THE PRECISE COMPOSITION OF THIS PRODUCT IS PROPRIETARY INFORMATION. A MORE
COMPLETE DISCLOSURE WILL BE PROVIDED TO A PHYSICIAN IN THE EVENT OF A MEDICAL
EMERGENCY.

SARA HAZARD: NONE NOTED (SECNON 311/312) TITLE III SECTION 313 - NOT LISTED

All components of this product are listed on the TSCA registry.


III. FIRE & EXPLOSION DATA

Flash Point, Base Oil: >620ºF (Pensky-Martens)     LEL: No Data

Extinguishing Media:
      Use carbon dioxide or dry chemical for small fires; aqueous foam or water
      for large fires.
Unusual Fire & Explosion Hazards:
      Closed containers may rupture (due to buildup of pressure) when exposed to
      extreme heat.
Special Fire Fighting Procedures:
      Wear self-contained breathing apparatus and complete personal protective
      equipment when entering confined areas where potential for exposure to
      vapors or products of combustion exists.


IV. REACTIVITY DATA

Stability:                           Stable                                   
Hazardous Polymerization:            Will not occur                           
Conditions to Avoid:                 Fire, excessive heat.                    
Materials to Avoid:                  Strong oxidizing agents.                 
Hazardous Decomposition Products:    Fumes produced when heated to            
                                     decomposition may include: carbon        
                                     monoxide, carbon dioxide.                


V. HEALTH HAZARD DATA

Effects of Overexposure:
      Ingestion: No specific information available.
      Contains materials that may be practically nontoxic.

      Inhalation: No specific information available.
      Heating can generate vapors that could cause headaches, nausea, dizziness,
      and respiratory irritation if inhaled.

      Skin Absorption: No specific information available.
      Contains materials that may be practically nontoxic.

      Skin Contact: No specific information available.
      Contains materials that may cause skin irritation on prolonged or repeated
      exposure.

      Eye Contact: No specific information available.
      Contains materials that may cause eye injury, which may persist for
      several days.

      Chronic Effects of Overexposure: No information available.

Emergency & First Aid Procedures:
      Eye Contact: Flush with plenty of water for at least 15 minutes and seek
      medical attention if irritation persists.

      Skin Contact: Remove contaminated clothing and wash contact area with soap
      and water for 15 minutes.

      Ingestion: If appreciable quantities are swallowed, seek medical
      attention.

      Inhalation: In case of over exposure to fumes if product is heated, remove
      person to fresh air. If breathing has stopped, administer artificial
      respiration and seek medical attention.


VI. WASTE DISPOSAL

Dispose of waste in accordance with federal, state, and local regulations.


VII. SPECIAL PROTECTION INFORMATION

Respiratory Protection:
      Wear a properly fitted NIOSH/MSHA approved respirator whenever exposure to
      vapor from heating product is likely and where ventilation is inadequate.

Ventilation:
      Local Exhaust: Recommended when appropriate to control employee exposure.
      Mechanical: Not recommended as the sole means of controlling employee
                  exposure.
      Protective Gloves: For operations where contact can occur, wear impervious
                         gloves.
      Eye Protection: Safety goggles.
      Other Protective Equipment: For operations where contact can occur, a
      safety shower and eye wash facility should be available.


VIII. SPECIAL PRECAUTIONS

Store it in a dry place. Keep container closed.


IX. TOXICOLOGICAL INFORMATION

Acute Toxicity: Relatively harmless [EL50 >1000 mg/L D. Magna (base oil)]


X. BIODEGRADABILITY INFORMATION

Components are readily biodegradable by OECD 301C (BOD/ThOD) Test Method.


XI. STATE R-T-K COMPOSITION INFORMATION (and Canada)

Component                      CAS#                      DSL       NDSL      
Soybean Oil                    8001-22-7                 ---       ---       
Fatty acid Lithium Soap        Mixture                   ---       ---       
Molybdenum Disulphide          1317-33-5                 ---       ---       
Additive Mixture**             Confidential              ---       ---       

**This information is being withheld by suppliers as trade secret
--- Not established


XII. SARA Title III, Section 313 Information:

This product does not contain any SARA Title III Section 313 chemicals.


XIII. RCRA Information

Regulated Waste: No


XIV. CERCLA INFORMATION

Under EPA-CERCLA releases to air, land, or water, which exceed the reportable
quantity, must be reported to the National Response Center (800-424-8802).

This product contains no materials with reportable quantities.


XV. California Proposition 65 Information:

To the best of our knowledge, this product does not contain any California
Proposition 65 designated chemicals.


XVI. Transportation Information

D.O.T. Shipping Name: Not Regulated
D.O.T. Hazard Class: Not Regulated
D.O.T. UN/NA Number: None


XVII. Other Information

None




To the best knowledge of Environmental Lubricants Manufacturing, Inc., the
information contained herein is accurate and reliable as of the date of this
material safety data sheet. However no liability whatsoever is assumed for the
accuracy or completeness of the information contained herein. Final
determination of suitability of any material is the sole responsibility of the
user. All materials may present unknown health hazards and should be used with
caution. Although certain hazards are described herein, we cannot guarantee
that these are the only hazards that exist.

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2010 Imperial Supplies LLC Questions or comments? Contact us.