MSDS 6607

*Estimate
N/A-Not Applicable
N/R-Not Restricted
N/E-Not Established

PERFORMIX BRAND
                       MATERIAL SAFETY DATA SHEET
NOTE: BLANK SPACES ARE NOT PERMITTED. IF ANY ITEM IS NOT APPLICABLE, THE SPACE
MUST BE MARKED TO INDICATE THAT.
IDENTITY                                            PART NO.
(As shown on Label or package) LIQUID TAPE SPRAY    IF APPLICABLE

SECTION I
MANUFACTURER'S                     EMERGENCY PHONE No.
NAME                               USA only: 1-800-424-9300 INT'L:
703-527-3887Plasti Dip International Inc.
ADDRESS (NUMBER, STREET, CITY, STATE AND ZIP CODE)            REVISION # 0001
3920 Pheasant Ridge Drive
Blaine, MN 55449                         MANUFACTURER'S PHONE
                                         No. FOR INFORMATION 1-763-785-2156
                                         DATE MSDS
                                         WAS PREPARED May 25, 2007

SECTION II - HAZARDOUS INGREDIENTS INFORMATION. All Health Hazards which
comprise 1% or greater of the composition and all
carcinogens if 0.1% of the composition or greater.
HAZARDOUS COMPONENTS CHEMICAL   % Wt.    CAS NO.    OSHA     ACGIH    OTHER  
IDENTITY AND COMMON NAME(S)   (OPTIONAL)             PEL      TLV     LIMITS
                                                                      RECOMMEND 
                         
   Propane                     20-25     74-98-6   1000 ppm  1000 ppm     None
   VM&P Naphtha                15-20   64742-89-8   300 ppm   300 ppm     None
   Xylene                      10-15   1330-20-7    100 ppm   100 ppm     None
   Heptane                     10-15   426260-76-6  500 ppm   400 ppm     None
   N-Butane                    10-15    106-97-8    800 ppm   800 ppm     None
   Ethylbenzene                1-5      100-41-4    100 ppm   100 ppm     None
   Methyl n-Amyl Ketone        1-5      110-43-0    100 ppm    50 ppm     None

SECTION III - PHYSICAL / CHEMICAL CHARACTERISTICS
BOILING           SPECIFIC GRAVITY (H20 =1)  APPROXIMATE WEIGHT PER GALLON (LBS)
POINT <0 ­ 325 °F         0.67                              5.59

VAPOR PRESSURE       VAPOR DENSITY                EVAPORATION RATE
760 mm Hg @ 20 °C    (AIR = 1) Heavier than Air   (BUTYL ACETATE =1) >1.0

SOLUBILITY IN WATER         % VOLATILE                  OTHER
  N/A                         87 %                     (IF ANY)

APPEARANCE
AND ODOR     Various colors, syrupy liquid, with solvent odor

SECTION IV-FIRE AND EXPLOSION HAZARD DATA
FLASH POINT        FLAMMABLE LIMITS           LEL                  UEL
Propellant < 0 °F                             0.9                  9.5

EXTINGUISHING
MEDIA        Carbon Dioxide, Dry Chemical, or Foam

SPECIAL FIRE FIGHTING
PROCEDURES       Self contained breathing apparatus with a full face piece,     
            operated in pressure demand or other positive pressure mode.

UNUSUAL FIRE AND   This material is flammable and may be ignited by heat,       
            sparks, flame or static electricity.
EXPLOSION HAZARDS  Level 3 aerosol (NFPA 30B). Contents under pressure if heated
                   over 120°F aerosol can could explode, even when empty.

HAZARDOUS PRODUCTS FORMED BY
FIRE OR THERMAL DECOMPOSITION     Carbon Dioxide and/or Carbon Monoxide

EXPLOSIVE LIMITS
(% BY VOLUME IN AIR)      0.9 -­ 9.5

SECTION V - OPTIONAL HAZARD RATINGS IDENTIFICATION
HAZARD RATING                 National Fire Protection Association (NFPA)
4-EXTREME
3-HIGH                         FIRE     4        REACTIVITY         0
2-MODERATE
1-SLIGHT
0-INSIGNIFICANT                HEALTH   2        SPECIAL HAZARDS    NONE 
**SEE SECTION IV

SECTION VI - REACTIVITY AND STABILITY DATA
STABILITY     UNSTABLE      STABLE X

INCOMPATIBILITY (Materials to Avoid) Strong acids, bases, oxidizing agents,     
            selected amines with alkali metals and halogens.

HAZARDOUS DECOMPOSITION OR BY PRODUCTS Carbon Monoxide and/or Carbon Dioxide

HAZARDOUS          MAY OCCUR               CONDITIONS TO AVOID
POLYMERIZATION     WILL NOT OCCUR X        Avoid contact with heat, sparks,     
                                          and open flame. Product may explode   
                                        if heated.

SECTION VII - HEALTH HAZARD DATA
ROUTES OF ENTRY    INHALATION? YES    SKIN? YES   INGESTION? YES    EYES? YES
HEALTH             ACUTE      X
HAZARDS            CHRONIC    X

CARCINOGENICITY:   IARC 2B

SIGNS AND
SYMPTOMS OF      Headache, Dizziness, Drowsiness, Fatigue, Irregular Heartbeat,
EXPOSURE         Skin and Eye Irritation.

MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE

EMERGENCY AND     Ingestion: Contact Physician or Poison Control Immediatley.
FIRST AID         Inhalation: Remove to fresh air. Administer Oxygen or
PROCEDURES        Artificial Respiration if Necessary.
                  Eye Contact: Flush with large amounts of water. If irritation 
                 persists, contact Physician.
                  Skin: Wash with soap and water.

SECTION VIII - PRECAUTIONS FOR SAFE HANDLING AND USE

STEPS TO BE TAKEN      Wipe up with floor absorbent. Transfer to hood. Prevent
IN CASE MATERIAL IS    run-off to sewers.
RELEASED OR SPILLED    Eliminate all sources of ignition.
                       Ventilate to maintain exposure below PELs.

WASTE DISPOSAL METHODS Dispose of product in accordance with local, county,     
                  state and federal regulations.

PRECAUTIONS TO BE      Keep away from sparks, flames, and heat sources.
TAKEN IN HANDLING      Do Not store above 120°F
AND STORAGE            Level 3 aerosol (NFPA 30B).

OTHER                  Keep Container Closed When Not In Use. Store this product
PRECAUTIONS            with adequate ventilation in cool areas.
                       Never place aerosol in flame or fire, Even when Empty.

SECTION IX - CONTROL MEASURES
RESPIRATORY PROTECTION (SPECIFY TYPE) Depending on the Airborne concentration   
use a Respirator with appropriate NIOSH approved cartridge or supplied air
equipment.
PROTECTIVE GLOVES   Impervious Gloves
VENTILATION       LOCAL EXHAUST Supplememental (if needed)                     
SPECIAL   None
MECHANICAL (GENERAL) To maintain exposure below PELs             
OTHER None
EYE PROTECTION                       
Chemical splash goggles, or approved eye protection.                           
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Chemcial Apron/Eye bath/Safety Shower
WORK HYGIENIC PRACTICES Wash thoroughly after handling.

SECTION X - TRANSPORTATION INFORMATION
DOT PROPER SHIPPING NAME Aerosols                   DOT HAZARD CLASS 2.1
DOT UN NUMBER UN 1950                               DOT PACKING GROUP N/A
IATA PROPER SHIPPING NAME Aerosols, flammable       IATA HAZARD CLASS 2.1
IATA UN NUMBER UN 1950                              IATA PACKING GROUP N/A

SECTION XI - 313 SUPPLIER NOTIFICATION
THIS PRODUCT CONTAINS THE FOLLOWING CHEMICALS SUBJECT TO REPORTING REQUIREMENTS
OF SECTION 313 OF THE EMERGENCY PLANNING AND COMMUNITY RIGHT-TO-KNOW ACT OF
1986, 40 CFR 372, (see table on page 1 for CAS # and percent by weight).
Xylene and Ethylbenzene
WARNING: THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE CANCER AND BIRTH  DEFECTS, OR OTHER REPRODUCTIVE HARM.
                         

Prepared By: Mark Kenow

   THE INFORMATION PROVIDED HEREIN IS BASED ON DATA CONSIDERED ACCURATE. NO
WARRANTY IS EXPRESSED OR IMPLIED REGARDING THE ACCURACY OF THE DATA OR THE
RESULTS OBTAINED FROM ITS USE.
   SINCE THE INFORMATION CONTAINED HEREIN MAY BE APPLIED UNDER CONDITIONS BEYOND
THE VENDORS CONTROL AND SINCE SUBSEQUENT DATA MAY SUGGEST MODIFICATION OF THE
INFORMATION. VENDOR ASSUMES NO RESPONSIBILITY FOR THE RESULTS OF ITS USE.

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.