MSDS 6505

                          MATERIAL SAFETY DATA SHEET

PART NO: 6505,6505-1 
PRODUCT NAME: FIFTH WHEEL LUBE

HMIS RATING:
HEALTH:       2
FLAMMABILITY: 4
REACTIVITY:   0
PERSONAL PR0T:


                                    SECTION 1


MANUFACTURER'S NAME:          IMPERIAL SUPPLIES LLC
MANUFACTURER'S ADDRESS:       789 PACKER DRIVE
CITY, STATE, ZIP:             GREEN BAY, WI. 54304
INFORMATION TELEPHONE NUMBER: 800-558-2808
EMERGENCY TELEPHONE NUMBER:   800-255-3924 (CHEM-TEL, INC.)
DATE CHANGED:                 9/16/02

DOT SHIPPING-CONSUMER COMMODITY ORM-D


              SECTION 2 --  COMPOSITION / INFORMATION ON INGREDIENTS


% by WT   CAS No.     INGREDIENT       UNITS                 VAPOR PRESSURE

15        74-98-6     Propane
                                       ACGIH TLV  2500  ppm    760  mm
                                       OSHA  PEL   1000  ppm
15        106-97-8    Butane
                                       ACGIH  TLV  800  ppm     760  mm
                                       OSHA   PEL  800  ppm
29        142-82-5    Heptane
                                       ACGIH  TLV  400  ppm     50  mm
                                       ACGIH  TLV  500  ppm  STEL
                                       OSHA  PEL   400  ppm
                                       OSHA  PEL   500  ppm  STEL
18        64742-52-5  Heavy Naphthenic Petroleum Oil.
                                       ACGIH  TLV  5 mg/m3  as Mist
                                       OSHA  PEL   5 mg/m3 as Mist
2         1317-33-5   Molybdenum Disulfide.
                                       ACGIH  TLV  10 mg/m3 as Dust
                                       OSHA  PEL   10 mg/m3 Total Dust
                                       OSHA  PEL   5  mg/m3  Respirable
                                                               Fraction
7         7782-42-5   Graphite
                                       ACGIH  TLV  2  mg/m3
                                       OSHA  PEL   2.5  mg/m3


                        SECTION 3 -HAZARDS IDENTIFICATION


ROUTES OF EXPOSURE
   Exposure may be by INHALATION and/or SKIN or EYE contact, depending on
   conditions of use. To minimize exposure, follow recommendations for proper
   use, ventilation, and personal protective equipment.

EFFECTS OF OVEREXPOSURE
   Irritation of eyes, skin and upper respiratory system. May cause nervous
   system depression. Extreme overexposure may result in unconsciousness and
   possibly death.

SIGNS AND SYMPTOMS OF OVEREXPOSURE
   Headache, dizziness, nausea, and loss of coordination are indications of
   excessive exposure to vapors or spray mists. Redness and itching or burning
   sensation may indicate eye or excessive skin exposure.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
   None generally recognized.

CANCER INFORMATION
   For complete discussion of toxicology data refer to Section 11.


                         SECTION 4 --  FIRST AID MEASURES


If INHALED;
   If affected, remove from exposure. Restore breathing. Keep warm and quiet.
If on SKIN;
   Wash affected area thoroughly with soap and water. Remove contaminated
   clothing and launder before re-use.
If in EYES:
   Flush eyes with large amounts of water for 15 minutes. Get medical attention.
If  SWALLOWED;
   Do not induce vomiting. Get medical attention immediately.


                       SECTION 5 --  FIRE FIGHTING MEASURES


FLASH POINT                  LEL                 UEL
Propellant  <  0  F          1.1                 10.0

EXTINGUISHING MEDIA
   Carbon Dioxide, Dry Chemical, Foam

UNUSUAL FIRE AND EXPLOSION HAZARDS
   Containers may explode when exposed to extreme heat. Application to hot
   surfaces requires special precautions. During emergency conditions
   overexposure to decomposition products may cause a health hazard. Symptoms
   may not be immediately apparent. Obtain medical attention.

SPECIAL FIRE FIGHTING PROCEDURES
   Full protective equipment including self-contained breathing apparatus should
   be used. Water spray may be ineffective. If water is used, fog nozzles are
   preferable. Water may be used to cool closed containers to prevent pressure
   build-up and possible autoignition or explosion when exposed to extreme heat.


                     SECTION 6 - ACCIDENTAL RELEASE MEASURES


STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
   Remove all sources of ignition. Ventilate the area. Remove with inert
   absorbent.


                         SECTION 7 - HANDLING AND STORAGE


STORAGE CATEGORY
      NFPA 30B Level 3 Aerosol

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
   Keep away from heat, sparks, and open flame. Vapors will accumulate readily
   and may ignite explosively. During use and until all vapors are gone: Keep
   area ventilated - Do not smoke - Extinguish all flames, pilot lights, and
   heater - Turn off stoves, electric tools and appliances, and any other
   sources of ignition. Consult NFPA Code. Use approved Bonding and Grounding
   procedures. Contents under pressure. Do not puncture, incinerate, or expose
   to temperature above 120F. Heat from sunlight, radiators, stoves, hot water,
   and other heat sources could cause container to burst. Do not take
   internally. Keep out of the reach of children.


              SECTION 8 --  EXPOSURE CONTROLS / PERSONAL PROTECTION


PRECAUTIONS TO BE TAKEN IN USE
   Use only with adequate ventilation. Avoid contact with skin and eyes. Avoid
   breathing vapor and spray mist. Wash hands after using.

VENTILATION
   Local exhaust preferable. General exhaust acceptable if the exposure to
   materials in Section 2 is maintained below applicable exposure limits. Refer
   to OSHA Standards 1910.94, 1910.107, 1910.108.

RESPIRATORY PROTECTION
   If personal exposure cannot be controlled below applicable limits by
   ventilation, wear a properly fitted organic vapor/particulate respirator
   approved by NIOSH/MSHA for protection against materials in Section 2.

PROTECTIVE GLOVES
   None required for normal application of aerosol products where minimal skin
   contact is expected. For long or repeated contact, wear chemical resistant
   gloves.

EYE PROTECTION
   Wear safety spectacles with unperforated sideshields.

OTHER PRECAUTIONS
   Intentional misuse by deliberately concentrating and inhaling the contents
   can be harmful or fatal.


                   SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES


PRODUCT WEIGHT                   6.17  lb/gal           739  g/l
SPECIFIC GRAVITY                 0.74
BOILING POINT                    <0 - 212 F            <-18 - 100 C
MELTING POINT                    Not Available
VOLATILE VOLUME                  73 %
EVAPORATION RATE                 Faster than ether
VAPOR DENSITY                    Heavier than air
SOLUBILITY IN WATER              N.A.
VOLATILE ORGANIC COMPOUNDS  (VOC Theoretical)
                                 Volatile Weight 60.00 %   Less Federally Exempt
                                 Solvents


                      SECTION 10 - STABILITY AND REACTIVITY


STABILITY -
   Stable

CONDITIONS TO AVOID --
   None known.

INCOMPATIBILITY --
   None known.

HAZARDOUS DECOMPOSITION PRODUCTS By fire:
   Carbon Dioxide, Carbon Monoxide

HAZARDOUS POLYMERIZATION --
   Will not occur.


                    SECTION  11 --  TOXICOLOGICAL INFORMATION


CHRONIC HEALTH HAZARDS
   No ingredient in this product is an IARC, NTP or OSHA listed
   carcinogen.Reports have associated repeated and prolonged overexposure to
   solvents with permanent brain and nervous system damage.

TOXICOLOGY DATA
CAS No.     Ingredient Name
--------------------------------------------------------------------------------
74-98-6     Propane
            LC50     RAT         4HR         Not Available
            LD50     RAT                     Not Available
106-97-8    Butane
            LC50     RAT          4HR        Not Available
            LD50     RAT                     Not Available
142-82-5    Heptane
            LC50     RAT          4HR        Not Available
            LD50     RAT                     Not Available
64742-52-5  Heavy Naphthenic Petroleum Oil
            LC50     RAT          4HR        Not Available
            LD50     RAT                     Not Available
1317-33-5   Molybdenum Disulfide.
            LC50     RAT           4HR       Not Available
            LD50     RAT                     Not Available
7782-42-5   Graphite
            LC50     RAT            4HR      Not Available
            LD50     RAT                     Not Available


                      SECTION 12 --  ECOLOGICAL INFORMATION


ECOTOXICOLOGICAL INFORMATION
                                No data available.



                       SECTION 13 - DISPOSAL CONSIDERATIONS


WASTE DISPOSAL METHOD
   Waste from this product may be hazardous as defined under the Resource
   Conservation and Recovery Act  (RCRA)  40  CFR  261.
   Waste must be tested for ignitability to determine the applicable EPA
   hazardous waste numbers. Do not incinerate. Depressurize container. Dispose
   of in accordance with Federal, State, and Local regulations regarding
   pollution.


                       SECTION 14 --  TRANSPORT INFORMATION


                                No data available.


                      SECTION 15 --  REGULATORY INFORMATION


SARA 313  (40 CFR 372.65C)  SUPPLIER NOTIFICATION

CAS No.      CHEMICAL / COMPOUND                     % by WT           % Element
   No ingredients in this product are subject to SARA 313  (40 CFR 372.6C5)
   Supplier Notification.

CALIFORNIA PROPOSITION 65
   WARNING:  This product contains chemicals known to the State of California to
   cause cancer and birth defects or other reproductive harm.

TSCA CERTIFICATION
   All chemicals in this product are listed, or are exempt from listing, on the
   TSCA Inventory.


                         SECTION 16 --  OTHER INFORMATION


This product has been classified in accordance with the hazard criteria of the
CPR and the MSDS contains all of the information required by the CPR.


         The above information pertains to this product as currently formulated,
and is based on the information available at this time.  Addition of reducers or
other additives to this product may substantially alter the composition and
hazards of the product. Since conditions of use are outside our control, we make
no warranties, express or implied, and assume no liability in connection with
any use of this information.

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.