MSDS 4042

Material Safety Data Sheet

MSDS ID: SK-117B

Issue Date: 01/24/06 Rev: 3.0000

* * * Section 1 - Chemical Product and Company Identification * * *

Product Name: KRESTO®

Product Use: Hand Cleanser

Manufacturer Information
Stockhausen, Inc. 2401 Doyle Street
Greensboro , NC 27406
Non-Emergency # 800-242-2271

Emergency # (800) 424-9300 CHEMTREC (North America)
Emergency # (703) 527-3887 CHEMTREC (International, call collect)

Emergency telephone numbers are to be used only in the event of chemical
emergencies involving a spill, leak, fire, exposure or accident involving the
product. All Non-emergency questions should be directed to the Toll Free, Non-
Emergency number above.


* * * Section 2 - Hazards Identification * * *

Emergency Overview
   No particular hazards known.
Potential Health Effects: Eyes
   This product may cause slight irritation to the eyes.
Potential Health Effects: Skin
   None.
Potential Health Effects: Ingestion
   Seek medical attention.
Potential Health Effects: Inhalation
   Prolonged inhalation may cause irritation and respiratory tract discomfort.

HMIS Ratings: Health: 1  Fire: 1  Reactivity: 0  Pers. Prot.: None required.
Hazard Scale:  0 = Minimal  1 = Slight  2 = Moderate  3 = Serious  4 = Severe 
* = Chronic hazard


* * * Section 3 - Composition / Information on Ingredients * * *

Component Information/Information on Non-Hazardous Components
   This product is a cosmetic intended for personal use in the workplace and is
   thus regulated by FDA.
   See container label regarding proper handling and use of this product.
   Ingredients are listed in descending order of concentration on the container
   label.
   For OSHA workplace hazards, investigate and read and understand component
   MSDS's before manufacturing.
   Toxic Substances Control Act (TSCA): Exempt
   Workplace Hazardous Materials Information System (WHIMS-Canada): Exempt-
   cosmetic hand cleanser


* * * Section 4 - First Aid Measures * * *

First Aid: Eyes
   In case of contact, immediately flush eyes with large amounts of water,
   continuing to flush for 15 minutes. If irritation persists get medical
   attention.
First Aid: Skin
   Intended as a cosmetic hand cleaner.
First Aid: Ingestion
   If material is swallowed, get medical attention or advice.
First Aid: Inhalation
   If symptoms are experienced, remove source of contamination or move victim to
   fresh air.


* * * Section 5 - Fire Fighting Measures * * *

General Fire Hazards
   None.

   Upper Flammable Limit (UFL): Not determined
   Lower Flammable Limit (LFL): Not determined
   Method Used: Estimated
   Flash Point: >200°F
   Flammability Classification: Not Determined
   Auto Ignition: Not determined
Hazardous Combustion Products
   None identified.
Extinguishing Media
   Dry chemical, foam, carbon dioxide, water fog.
Fire Fighting Equipment/Instructions
   Firefighters should wear self-contained air supplied breathing apparatus in
   enclosed areas or in areas of heavy smoke or fumes.

NFPA Ratings: Health: 1 Fire: 1 Reactivity: 0

Hazard Scale: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe


* * * Section 6 - Accidental Release Measures * * *

Containment Procedures
   Absorb spill with inert material.
Clean-Up Procedures
   Absorb spill with inert material. Shovel material into appropriate container
   for disposal. Flush small residuals to the drain for normal biological
   wastewater treatment.
Evacuation Procedures
   None.
Special Procedures
   None.


* * * Section 7 - Handling and Storage * * *

Handling Procedures
   Keep container closed. See container label for proper use.
Storage Procedures
   Protect from freezing or extreme heat.


* * * Section 8 - Exposure Controls / Personal Protection * * *

Exposure Guidelines
A: General Product Information
   FDA regulated. For OSHA workplace hazards, investigate and read and
   understand component MSDS's before manufacturing.

B: Component Exposure Limits
   No information is available.
Engineering Controls
   None necessary.

PERSONAL PROTECTIVE EQUIPMENT
Personal Protective Equipment: Eyes/Face
   Avoid eye contact.
Personal Protective Equipment: Skin
   None.
Personal Protective Equipment: Respiratory
   Not required for product end use.
Personal Protective Equipment: General
   Obey reasonable safety precautions and practice good housekeeping.


* * * Section 9 - Physical & Chemical Properties * * *

Appearance: Viscous off-white liquid
Odor: perfume fragrance (0.1-1%)
Physical State: liquid (Emulsion)
pH: 6.0 - 7.0
Vapor Pressure: 0.07 mm Hg
Vapor Density: Not Established
Boiling Point: >212 °F
Melting Point: 32° F
Solubility (H2O): approximately 25% soluble in water
Specific Gravity: 1.05 g/cc3
Evaporation Rate: <1
Flash Point: >200°F (Estimated)
Percent Volatile: 0% (Federal); LVP-VOC only (California


* * * Section 10 - Chemical Stability & Reactivity Information * * *

Chemical Stability
   Stable under usual application conditions.
Chemical Stability: Conditions to Avoid
   None.
Incompatibility
   None identified.
Hazardous Decomposition
   None identified.
Hazardous Polymerization
   Hazardous polymerization will not occur.


* * * Section 11 - Toxicological Information * * *

Acute and Chronic Toxicity
A: General Product Information
   Adverse effects on human health are not to be expected in normal use.
B: Acute Toxicity-LD50/LC50
   No LD50/LC50's are available for this product's components.
Carcinogenicity
A: General Product Information
   Not listed by ACGIH, IARC, NIOSH, NTP OR OSHA.
B: Component Carcinogenicity
   No information is available.
Other Toxicological Information
   None.


* * * Section 12 - Ecological Information * * *

Ecotoxicity
A: General Product Information
   No information available.
B: Component Analysis - Ecotoxicity - Aquatic Toxicity
   No information available,
Environmental Fate
   No information available.


* * * Section 13 - Disposal Considerations * * *

US EPA Waste Number & Descriptions
A: General Product Information
   Controlled release of diluted product into a biological wastewater treatment
   plant.
B: Component Waste Numbers
   No EPA Waste Numbers are applicable for this product's components.
Disposal Instructions
   Dispose of waste material according to Local, State, Federal, and Provincial
   Environmental Regulations.


* * * Section 14 - Transportation Information * * *

International Transportation Regulations
   This product is not regulated as a hazardous material by the United States
   (DOT) or Canadian (TDG) transportation regulations.


* * * Section 15 - Regulatory Information * * *

US Federal Regulations
A: General Product Information
   Not regulated under the Clean Air Act, Not subject to TSCA regulation.
   Regulated as a personal use cosmetic by FDA.
B: Clean Air Act
   No information is available.
C: Component Analysis
   No information is available.
D: Food & Drug Administration
   None of the components in this product are listed by the FDA under
   regulations for Direct and Indirect Food Additives.

State Regulations
A: General Product Information
   California: Volatiles are LVP -VOC's, fragrance is <2% exempt.
B: Component Analysis - State
   None of this product's components are listed on the state lists from CA, FL,
   MA, MN, NJ, or PA.

Component Analysis - WHMIS IDL
   Bronopol @ < 0.1% (CAS # 52-51-7) is listed in the WHMIS IDL.


* * * Section 16 - Other Information * * *

Other Information
   The information provided in this Material Safety Data Sheet is correct to the
   best of our knowledge, information and belief at the date of its publication.
   The information given is designed only as guidance for safe handling, use,
   processing, storage, transportation, disposal and release and is not to be
   considered a warranty or quality specification. The information relates only
   to the specific material designated and may not be valid for such material
   used in combination with any other materials or in any process unless
   specified in the text.

MSDS History
   This is a revised MSDS. Section's 2 & 3 have been revised to reflect proposed
   2004 ANSI Standards format recommendations for 2007 implementation.

Key/Legend
   LVP-VOC: Low Vapor Pressure -Volatile Organic Compound (California)

Contact: Product Compliance Officer

Contact Phone: (800) 242-2271




                       This is the end of MSDS ID: SK-117B

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.