MSDS 3510

                 MSDS SHEET FOR KWIK SEAL TUB & TILE #3510 

            *** SECTION 1 PRODUCT IDENTIFICATION ***

MANUFACTURER'S NAME:      DAP INC.
MANUFACTURER'S ADDRESS:   P.O. BOX 277
                          DAYTON, OH  45401-0277
EMERGENCY TELEPHONE:      1-800-535-5053 (TRANSPORTATION)
                          1-800-327-3874 (MEDICAL)

DISTRIBUTOR'S NAME:       IMPERIAL SUPPLIES LLC
DISTRIBUTOR'S ADDRESS:    789 PACKER DRIVE
                          GREEN BAY, WI  54304
INFORMATION TELEPHONE:    1-800-558-2808  

PRODUCT NAME:             KWIK SEAL TUB & TILE WH
PRODUCT NO.:              18001
IMPERIAL NO.:             3510

             *** SECTION 2 HAZARDOUS INGREDIENTS ***

ITEM      CHEMICAL NAME            CAS #          %

01       CALCIUM CARBONATE       1317-65-3     40-50
02       TITANIUM DIOXIDE       13463-67-7      1-5
03       PHTHALATE ESTERS       PROPRIETARY     1-5
 
                           EXPOSURE LIMITS
                ACGIH                  OSHA                COMPANY
ITEM     TLV-TWA     TLV-STEL   PEL-TWA     PEL-CEILING    TLV-TWA   SKIN

O1     10 MG/M3      N.E.        15 MG/M3      N.E.           N.E.     NO
02     10 MG/M3 DUST N.E.        10 MG/M3 DUST N.E.      5 MG/M3 DUST  NO
03     N.E.          N.E.        N.E.          N.E.            N.E.    NO

             *** SECTION 3 HAZARDS IDENTIFICATION ***

EMERGENCY OVERVIEW:  CAUTION!  MAY CAUSE EYE AND SKIN IRRITATION.

POTENTIAL HEALTH EFFECTS:
  EFFECTS OF OVEREXPOSURE:  EYE CONTACT:  MAY CAUSE EYE IRRITATION.
  EFFECTS OF OVEREXPOSURE:  SKIN CONTACT:  PROLONGED OR REPEATED CONTACT WITH   
                            SKIN MAY CAUSE IRRITATION.
  EFFECTS OF OVEREXPOSURE:  INHALATION:  VAPOR MAY CAUSE NOSE AND THROAT        
                            IRRITATION.
  EFFECTS OF OVEREXPOSURE:  INGESTION:  NONE KNOWN.
  EFFECTS OF OVEREXPOSURE:  CHRONIC HAZARDS:  PROLONGED OR REPEATED CONTACT     
                            WITH SKIN MAY CAUSE IRRITATION.
MEDICAL CONDITIONS WHICH MAY BE AGGRAVATED BY CONTACT:  NONE KNOWN.

PRIMARY ROUTES OF ENTRY:  SKIN AND EYE CONTACT

             *** SECTION 4 FIRST AID MEASURES ***

EYE CONTACT:  FLUSH WITH LARGE QUANTITIES OF WATER UNTIL IRRITATION SUBSIDES.
SKIN CONTACT:  WASH WITH SOAP AND WATER.
INHALATION:  REMOVE TO FRESH AIR.
INGESTION:  DO NOT INDUCE VOMITING.
COMMENTS:  CALL MEDICAL IN SECTION 1 IF IRRITATION OR COMPLICATIONS ARISE FROM  
           ANY OF THE ABOVE ROUTES OF ENTRY.

          *** SECTION 5 FIRE FIGHTING MEASURES ***

FLASH POINT: >200 F     SETAFLASH CLOSED CUP
LEL:  N.A.
UEL:  N.A.
AUTOIGNITION TEMPERATURE:  N.A.
EXTINGUISHING MEDIA:  CO2, DRY CHEMICAL, FOAM, WATER FOG
UNUSUAL FIRE AND EXPLOSION HAZARDS:  NONE KNOWN.
SPECIAL FIREFIGHTING PROCEDURES:  AS IN ANY FIRE, WEAR SELF-CONTAINED BREATHING 
          APPARATUS PRESSURE-DEMAND (MSHA/NIOSH APPROVED OR EQUIVALENT) AND     
          FULL PROTECTIVE GEAR.  USE WATER SPRAY TO COOL EXPOSED SURFACES.

                 *** SECTION 6 ACCIDENTAL RELEASE MEASURES ***

SPILL OR LEAK PROCEDURES:  USE ABSORBENT MATERIAL OR SCRAPE UP DRIED MATERIAL   
                           AND PLACE INTO CONTAINERS.

               *** SECTION 7 HANDLING & STORAGE ***

HANDLING INFORMATION:  KEEP OUT OF REACH OF CHILDREN.  AVOID PROLONGED OR       
                       REPEATED CONTACT WITH SKIN.  AVOID CONTACT WITH EYES.
STORAGE INFORMATION:  STORE AWAY FROM CASUTICS AND OXIDIZERS.  KEEP CONTAINERS  
                      TIGHTLY CLOSED WHEN NOT IN USE.  KEEP CONTAINERS FROM     
                      EXCESSIVE HEAT AND FREEZING.  DO NOT STORE AT TEMPERATURES
                      ABOVE 120 DEGREES F.
OTHER PRECAUTIONS:  NONE.

                *** SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION ***

ENGINEERING CONTROLS:  NORMAL ROOM VENTILATION.
RESPIRATORY PROTECTION:  A RESPIRATORY PROTECTION PROGRAM THAT MEETS OSHA       
                         1910.134 AND ANSI Z88.2 REQUIREMENTS MUST BE FOLLOWED  
                         WHENEVER WORKPLACE CONDITIONS WARRANT A RESPIRATOR'S   
                         USE.  NOT REQUIRED UNDER NORMAL USAGE AND ADEQUATE     
                         VENTILATION.
EYE PROTECTION:  SAFETY GLASSES WITH SIDE SHIELDS RECOMMENDED.
SKIN PROTECTION:  NONE REQUIRED.
OTHER PROTECTIVE EQUIPMENT:  NONE.
HYGIENIC PRACTICES:  ALTHOUGH THIS PRODUCT IS NOT CONSIDERED AN EYE IRRITANT,   
                     INHALATION HAZARD, OR A SKIN CONTACT HAZARD UNDER NORMAL   
                     CONDITIONS, IT IS ADVISABLE THAT PERSONNEL MINIMIZESKIN    
                     CONTACT, INHALATION OF VAPORS, AND EYE CONTACT.  WASH      
                     CONTAMINATED CLOTHING BEFORE REUSE.

               *** SECTION 9 PHYSICAL & CHEMICAL PROPERTIES ***

BOILING RANGE:  210-220 F
ODOR:  SLIGHT AMMONIA
APPEARANCE:  COLORED PASTE
SOLUBILITY IN H20:  NEGLIGIBLE
SPECIFIC GRAVITY:  1.5-1.6
VAPOR PRESSURE:  17 MM HG @ 68 F
PHYSICAL STATE:  PASTE
VAPOR DENSITY:  IS HEAVIER THAN AIR
EVAPORATION RATE:  IS SLOWER THAN BUTYL ACETATE

                *** SECTION 10 STABILITY & REACTIVITY ***

CONDITIONS TO AVOID:  EXCESSIVE HEAT AND FREEZING.
INCOMPATIBILITY:  STRONG OXIDIZERS AND CAUSTICS.
HAZARDOUS DECOMPOSITION PRODUCTS:  NORMAL DECOMPOSITION PRODUCTS, I.E. COx, NOx
HAZARDOUS POLYMERIZATION:  WILL NOT OCCUR UNDER NORMAL CONDITIONS.
STABILITY:  THIS PRODUCT IS STABLE UNDER NORMAL STORAGE CONDITIONS.

              *** SECTION 11 TOXICOLOGICAL PROPERTIES ***

NO PRODUCT OR COMPONENT TOXICOLOGICAL INFORMATION IS AVAILABLE.

               *** SECTION 12 ECOLOGICAL INFORMATION ***

NO INFORMATION
 
               *** SECTION 13 DISPOSAL CONSIDERATIONS ***

WASTE MANAGEMENT/DISPOSAL:  DISPOSE OF ACCORDING TO FEDERAL, STATE, AND LOCAL   
 STANDARDS.  THIS PRODUCT DOES NOT MEET THE DEFINITION OF A HAZARDOUS WASTE    
 ACCORDING TO U.S. EPA HAZARDOUS WASTE MANAGEMENT REGULATIONS, 40 CFR SECTION   
261.  STATE AND LOCAL REGULATIONS/RESTRICTIONS ARE COMPLESX AND MAY DIFFER    
 FROM FEDERAL REGULATIONS.  RESPONSIBILITY FOR PROPER WASTE DISPOSAL IS WITH    
 THE OWNER OF THE WASTE.

EPA WASTE CODE:  IF DISCARDED (40 CFR 261):  NONE.

             *** SECTION 14 TRANSPORTATION INFORMATION ***

DOT PROPER SHIPPING NAME:  NOT REGULATED BY D.0.T.
DOT HAZARD CLASS:  NONE
DOT UN/NA NUMBER:  NONE
PACKING GROUP:  NONE

             *** SECTION 15 REGULATORY INFORMATION ***

U.S. FEDERAL REGULATIONS:  AS FOLLOWS -

OSHA:  HAZARDOUS BY DEFINITION OF HAZARD COMMUNICATION STANDARD (29 CFR
1910.1200)

SARA SECTION 313:
THIS PRODUCT CONTAINS THE FOLLOWING SUBSTANCES SUBJECT TO THE REPORTING
REQUIREMENTS OF SECTION 313 OF TITLE III OF THE SUPERFUND AMENDMENTS AND
REAUTHORIZATION ACT OF 1986 AND 40 CFR PART 372:
             NONE.

TOXIC SUBSTANCES CONTROL ACT: 
THIS PRODUCT CONTAINS THE FOLLOWING CHEMICAL SUBSTANCES SUBJECT TO THE REPORTING
REQUIREMENTS OF TSCA 12(B) IF EXPORTED FROM THE UNITED STATES:
             NONE.

NEW JERSEY RIGHT-TO-KNOW:
THE FOLLOWING MATERIALS ARE NON-HAZARDOUS, BUT ARE AMONG THE TOP FIVE COMPONENTS
IN THIS PRODUCT:

ACRYLIC POLYMER, WATER, VINYL ACETATE COPOLYMER

PENNSYLVANIA RIGHT-TO-KNOW:
THE FOLLOWING NON-HAZARDOUS INGREDIENTS ARE PRESENT IN THE PRODUCT AT GREATER
THAN 3%:

ACRYLIC POLYMER, WATER, VINYL ACETATE COPOLYMER

CALIFORNIA PROPOSITION 65:
WARNING:  THE CHEMCICAL NOTED BELOW AND CONTAINED IN THIS PRODUCT, ARE KNOWN TO
THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM:
               NONE.

INTERNATIONAL REGULATIONS:  AS FOLLOWS -

CANADIAN WHMIS:  THIS MSDS HAS BEEN PREPARED IN COMPLIANCE WITH CONTROLLED
PRODUCT REGULATIONS EXCEPT FOR USE OF THE 16 HEADINGS.

CANADIAN WHMIS CLASS:  NOT REGULATED.

             *** SECTION 16 OTHER INFORMATION ***

HMIS RATINGS - HEALTH:  1      FLAMMABILITY:  1     REACTIVITY:  0
VOC LESS WATER, LESS EXEMPT SOLVENTS:  20-30 GM/1(1-2%)
VOC MATERIAL:  15-20 GM/1

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2008 Imperial Supplies LLC Questions or comments? Contact us.