MSDS 382

Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: 813-248-0585

                     Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product Name:             BEARING MOUNT FOR CLOSE FITS 50ML
Item No:                  60950
Product Type:             Anaerobic

2. COMPOSITION/INFORMATION ON INGREDIENTS
Component                Weight%           ACGIH TLV: TWA          OSHA PEL:
METHACRYLATE MONOMER     55-75              Not Listed            Not Listed
25852-47-5

2-HYDROXYETHYL           15-35              Not Listed            Not Listed
METHACRYLATE
868-77-9

COUMARONE-INDENE RESIN    <10               Not Listed            Not Listed
MIXTURE

POLY(ETHYL METHACRYLATE)  <5                Not Listed            Not Listed
9003-42-3
                                          
DIMETHYLBENZYL            <3                Not Listed            Not Listed
HYDROPEROXIDE
80-15-9


3. HAZARDS IDENTIFICATION
Toxicity:         May cause eye and skin irritation. At elevated temperatures   
                  may cause irritation of the respiratory tract.
                  Irritates mucous membranes. Ingestion may irritate digestive  
                  tract and cause nausea, vomiting and a diarrhea. May cause    
                  skin sensitization.
Primary Routes of Entry:   Eye and skin contact, ingestion, inhalation
Signs and Symptoms of Expsoure:  May cause redness to eyes and irritation to    
                  nasal passages. Repeated skin contact may cause allergic
                  skin reactions. Ingestion may cause nausea and vomiting.      
                  Inhalation overexposure may cause irritation,
                  coughing and flu-like symptoms. May cause pain, redness or    
                  swelling of the eyes and excessive blinking and tear          
                  production.

                                  
Medical Conditions Recognized as  May aggrevate preexisting dermatitis. 
Being Aggravated by Exposure:

4. FIRST AID MEASURES
Ingestion:        If swallowed, DO NOT induce vomiting. Keep individual calm.   
                  Obtain medical attention.
Inhalation:       Move to fresh air in case of accidental inhalation of         
                  vapours. Oxygen or artificial respiration if needed.
                  Obtain medical attention.
Skin Contact:     Wash off with soap and water. If skin irritation persists,    
                  call a physician.
Eye Contact:      In case of contact, immediately flush eyes with plenty of     
                  water for at least 15 minutes and get medical
                  attention if irritation persists.

5. FIRE FIGHTING MEASURES
Flash Point (°F/C):               >200 degrees F   PMCC
Recommended Extinguishing Media:  Water fog, carbon dioxide, foam, dry          
                                  chemical.
Special Fire-Fighting Procedures: Firefighters should wear self-contained       
                                  breathing apparatus.
Hazardous Products of Combustion: Irritating vapors, Oxides of carbon
Unusual Fire/Explosion Hazards:   Closed containers may rupture or explode when 
                                  exposed to extreme heat.
                                    
Lower Explosive Limit:            Not determined
Upper Explosive Limit:            Not determined

6. ACCIDENTAL RELEASE MEASURES
Spill Procedures:   Maintain good ventilation. Take up with an inert       
                    absorbent. Store in a closed waste container until          
                    disposal.


7. HANDLING AND STORAGE
Storage:                Store below 100 degrees F.
Handling:               Avoid prolonged skin contact. Keep away from eyes. Do   
                        not inhale vapors.


8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes:                Safety glasses
Skin:                Rubber or plastic gloves
Ventilation:         General; local exhaust ventilation as necessary to         
                     control any air contaminants to within their exposure
                     limits (or to the lowest feasible levels when limits have  
                     not been established) during the use of this product.
Respiratory Protection:  An approved respirator (i.e. NIOSH, etc.) should be    
                     worn when exposures are expected to exceed the
                     applicable limits.


9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance:             Green liquid
Odor:                   IRRITATING
Boiling Point:          Not determined
pH:                     Does not apply
Solubility in Water:    Insoluble
Specific Gravity:       1.05-1.15
VOC Content(Wt.%):      <2% by weight
Vapor Pressure:         5 mm Hg @ 25°C
Vapor Density (Air=1):  Heavier than air
Evaporation Rate:       Not determined


10. STABILITY AND REACTIVITY
Chemical Stability:        Stable at normal conditions
Hazardous Polymerization:  WILL NOT OCCUR.
Incompatabilities:         Active metal ions, heat, strong light.
Conditions to Avoid:       Heat
Hazardous Products of Combustion:  Irritating vapors, Oxides of carbon


11. TOXICOLOGICAL INFORMATION
See Section 3


12. ECOLOGICAL INFORMATION
No data available

13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with
federal, state and local regulations.
US EPA Waste Number:  NH - Not a RCRA Hazardous Waste Material

14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
DOT Shippping Name:   Unrestricted
Hazard Class:         None   
UN/ID Number:         None
Marine Pollutant:     None
       

IATA
Proper Shipping Name:   Not regulated
Class or Division:      None
UN/NA Number:           None      
                        
IMDG
Proper Shipping:        Unrestricted
Hazard Class:           None
UN Number:              None
                                     
                                    
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313
Toxic Chemical.

DIMETHYLBENZYL HYDROPEROXIDE

CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No
Significant Risk Level.

TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt)
on the EPA TSCA inventory.

16. OTHER INFORMATION
Estimated NFPA Rating:          HEALTH 2, FLAMMABILITY 1 , REACTIVITY 1.
Estimated HMIS Classification:  HEALTH 2, FLAMMABILILTY 1, PHYSICAL HAZARD 0
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.



Prepared By:     Denise Boyd, Health and Safety Manager
                 Revision Date: January/02/2008
Company:         Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106        
                 Revision   1
                 Number:

                                         




                                 3 of 3

The information contained in this MSDS was obtained from current and reliable sources, however, the data is provided without any warrenty, expressed or implied, regarding its correctness or accuracy. Since the conditions or handling, storage and disposal of this product are beyond the control of Imperial Supplies LLC, Imperial will not be responsible for loss, injury, or expense arising out of the products improper use. No warranty, expressed or inferred, regarding the product described in this MSDS shall be created or inferred by any statement in this MSDS. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.

© 2010 Imperial Supplies LLC Questions or comments? Contact us.